ParkerVision 1-CCD manual Switch Configuration

Installation and Startup

Switch Configuration

Now that you have connected your camera to the power supply and control devices, you need to configure the camera to work in your specific application. To begin, remove the switch plate on the back right side of the camera by removing the two screws holding it in place. Behind the plate you will see all of the configuration switches.

Refer to the next page for a table describing the switches.

	S-VI DEO
SWITCH BA NK		SWITCH BA NK
-A-		-B-
	COMPOSI TE

1	2	3	4	5	6	7	8	BA SE UNIT	1	2	3	4	5	6	7	8	TALLY LIGHT
								ADDRESS									INTERFACE
UP
DOWN

This diagram shows the default switch configuration of the camera as shipped.

Video Out Switch

						S-VIDEO
SWITCH BANK							SWITCH BANK
			-A-			COMPOSITE	-B-
1	2	3	4 5	6	7 8	BASE UNIT	1 2 3 4 5 6 7 8
						ADDRESS
UP
DOWN

Switches A1 – A8	Base Unit Switches B1 – B8
	Address Switch

Up

Down

2-16CameraMan 1-CCD Camera System Installation and Operations Manual