ParkerVision 1-CCD manual Connecting to the RS-232 Port

Installation and Startup

!Verify that the Video Select switch is set to S-VIDEO.

The switch is located behind the switch plate on the back right of the camera. Refer to the "Switch Configuration" topic in this section.

For video output specifications, refer to Appendix B,

Camera Specifications.

Connecting to the RS-232 Port

COM light

CameraMan provides for RS-232 communications using the DB-9 jack on the back of the camera, labeled RS-232. You can use this port to control the camera using external devices such as a PC or other vendor-control system such as AMXTM and CrestonTM.

Our RS-232 protocol is available by calling Customer Support at (800)532-8034.

Connect to this port using a standard computer cable with a DB-9 connector. This port operates with No Parity and software hand- shaking using ParkerVision High Reliability or Basic protocols.

!	Verify the protocol being used by checking the Protocol
	switch on the camera. Refer to the "Switch
	Configuration" topic in this section.

The COM light above the RS-232port is used to indicate communication activity.

For the DB-9 pin-out port information, refer to Appendix

D, Pin-out Diagrams.

CameraMan 1-CCD Camera System Installation and Operations Manual 2-13