ParkerVision 1-CCD manual System Startup, Powering Up, Setting Up Gen Lock, To turn on the system

Installation and Startup

System Startup

Once you have made all of the necessary connections and configured the camera to your application, you are ready to turn on the system.

Powering Up

To turn on the system:

1.Switch the Power button on the back of the camera to the ON position. The camera should automatically enter its position- calibration mode and stop at the zero-degree pan/tilt point.

2.Verify that the camera is now facing in the direction the FRONT

label was pointing during mounting. Refer to the "Mounting Your CameraMan Camera" topic in this section.

3.If you are using the optional Camera Control Keypad, make sure its address is the same as the address on the camera. Also verify that the camera's pan and tilt functions are working properly.

If the camera does not move, refer to the
Troubleshooting section of your Camera Control Keypad
or SHOT Director manual.	PVI COM	RS -232	S-VI DEO	COMPOSITE	DC
			OUT	VIDEO OUT	POWER
	RS-485	AUX A
					POWER

Setting Up Gen Lock

Refer to either of the following manuals for instructions on adjusting gen lock timing parameters:

•CameraMan 1-CCD Camera Control Keypad Operations Manual

•SHOT Director Installation and Operations Manual

2-18CameraMan 1-CCD Camera System Installation and Operations Manual