Edimax Technology IC-1520DPG R&TTE Compliance Statement, Safety, EU Countries Intended for Use

Page 27
R&TTE Compliance Statement

R&TTE Compliance Statement

This equipment complies with all the requirements of DIRECTIVE 1999/5/EC OF THE EUROPEAN PARLIAMENT AND THE COUNCIL of March 9, 1999 on radio equipment and telecommunication terminal Equipment and the mutual recognition of their conformity (R&TTE)

The R&TTE Directive repeals and replaces in the directive 98/13/EEC (Telecommunications Terminal Equipment and Satellite Earth Station Equipment) As of April 8, 2000.

Safety

This equipment is designed with the utmost care for the safety of those who install and use it. However, special attention must be paid to the dangers of electric shock and static electricity when working with electrical equipment. All guidelines of this and of the computer manufacture must therefore be allowed at all times to ensure the safe use of the equipment.

EU Countries Intended for Use

The ETSI version of this device is intended for home and office use in Austria, Belgium, Denmark, Finland, France, Germany, Greece, Ireland, Italy, Luxembourg, the Netherlands, Portugal, Spain, Sweden, and the United Kingdom.

The ETSI version of this device is also authorized for use in EFTA member states: Iceland, Liechtenstein, Norway, and Switzerland.

EU Countries not intended for use

None

23

Image 27
Contents Digital Pan/Tilt Internet Camera Version 1.0 OctoberWire / Wireless / Power over Ethernet Quick Installation Guide=================================== Multi-Languages QIG on the CDHardware Installation ContentCheck your package contents 4.1 Firmware UpgradeLinux Open Source Code English„ One Antenna For IC-1520DPg Only 1. Check your package contentsStatus 2. Hardware Installation2.1. LED and Focusing 1.1. System Requirementy Power y LANy WLAN For IC-1520DPg only y Reset y AntennaThe Camera features two ports and a Reset button 2.2. Installation Procedure 2.3. Locate the IP Address 3. Right-click ‘Local Area Connection’, and click ‘Properties’ 2. Double-click ‘Network Connections’ icon4. Select ‘Internet Protocol TCP/IP’, then click ‘Properties’ Page 3. Web Management Interface When you’re prompted, click ‘Install’ to continue You should be able to see the image from camera now Note If you see one of these messages or both4. Software Installation Page 6. The system will install the program automatically 5. Click “Install” to start installing the program7. Click “Finish” to complete the software installation software, you may see the following or similar messagePage “N” means the camera is new and not Page Page 4.1 Firmware Upgrade of your computer does not begin with ‘192.168.2’ NOTE IP address will be reset to default valueaddress setting of your computer if the IP address ‘192.168.2.3’ also. You’ll need to change the IPEU Countries not intended for use SafetyR&TTE Compliance Statement EU Countries Intended for Use