Edimax Technology IC-1520DPG, IC-1520POE manual Installation Procedure

Page 9

2.2.Installation Procedure

2.2.Installation Procedure

1.Unpack the Internet Camera package and verify that all the items listed in the Chapter 1 are provided.

2.Connect the Internet Camera to your network by attached the network cable from the switch/router to the LAN port of the Internet Camera.

3.Connect the power adapter to the Internet Camera and plug the power adapter to power outlet. The Internet Camera will be powered on. When the Internet Camera is ready, the Ready LED will light.

Note: It is highly recommended to use the power adapter shipped with the Internet Camera, do NOT use any other power adapter from any sources.

5

Image 9

Contents Wire / Wireless / Power over Ethernet Version 1.0 OctoberQuick Installation Guide Digital Pan/Tilt Internet Camera=================================== Multi-Languages QIG on the CDCheck your package contents Content4.1 Firmware Upgrade Hardware InstallationLinux Open Source Code English„ One Antenna For IC-1520DPg Only 1. Check your package contents2.1. LED and Focusing 2. Hardware Installation1.1. System Requirement Statusy Power y LANy WLAN For IC-1520DPg only y Reset y AntennaThe Camera features two ports and a Reset button 2.2. Installation Procedure 2.3. Locate the IP Address 3. Right-click ‘Local Area Connection’, and click ‘Properties’ 2. Double-click ‘Network Connections’ icon4. Select ‘Internet Protocol TCP/IP’, then click ‘Properties’ Page 3. Web Management Interface When you’re prompted, click ‘Install’ to continue You should be able to see the image from camera now Note If you see one of these messages or both4. Software Installation Page 6. The system will install the program automatically 5. Click “Install” to start installing the program7. Click “Finish” to complete the software installation software, you may see the following or similar messagePage “N” means the camera is new and not Page Page 4.1 Firmware Upgrade address setting of your computer if the IP address NOTE IP address will be reset to default value‘192.168.2.3’ also. You’ll need to change the IP of your computer does not begin with ‘192.168.2’R&TTE Compliance Statement SafetyEU Countries Intended for Use EU Countries not intended for use