Edimax Technology IC-1520DPG Hardware Installation, System Requirement, LED and Focusing, Status

Page 6
1.1. System Requirement

1.1. System Requirement

System requirement for PC, MAC or Notebook PC to access the Internet Camera are:

„OS System: Windows 98, ME, 2000, XP + SP2, Server 2003

„CPU: Intel Pentium III 750MHz above or Intel Celeron 1GHz above

„Memory Size: 128MB (256MB recommended)

„VGA Card Resolution: 800 x 600 or above

2.Hardware Installation

2.1.LED and Focusing

The Camera head and its focus ring allow you to modify the aim and focus of the Camera.

To adjust the Camera’s focus, rotate the dark focus ring.

There are three LEDs indicating the camera status and networking status.

LED

Status

Description

Name

 

 

LAN

Off

Network cable is disconnected

 

On

Network cable is connected

 

Flash

Transferring data via LAN port

WLAN

Off

No wireless LAN activity

(IC-1520DPg only)

On

Transferring data via wireless LAN

Power

Off

Camera is not powered (camera off)

 

On

Camera is correctly powered

 

 

(camera on)

2

Image 6
Contents Quick Installation Guide Version 1.0 OctoberWire / Wireless / Power over Ethernet Digital Pan/Tilt Internet CameraMulti-Languages QIG on the CD ===================================4.1 Firmware Upgrade ContentCheck your package contents Hardware InstallationEnglish Linux Open Source Code1. Check your package contents „ One Antenna For IC-1520DPg Only1.1. System Requirement 2. Hardware Installation2.1. LED and Focusing Statusy Power y LANy WLAN For IC-1520DPg only y Reset y AntennaThe Camera features two ports and a Reset button 2.2. Installation Procedure 2.3. Locate the IP Address 2. Double-click ‘Network Connections’ icon 3. Right-click ‘Local Area Connection’, and click ‘Properties’4. Select ‘Internet Protocol TCP/IP’, then click ‘Properties’ Page 3. Web Management Interface When you’re prompted, click ‘Install’ to continue Note If you see one of these messages or both You should be able to see the image from camera now4. Software Installation Page 5. Click “Install” to start installing the program 6. The system will install the program automaticallysoftware, you may see the following or similar message 7. Click “Finish” to complete the software installationPage “N” means the camera is new and not Page Page 4.1 Firmware Upgrade ‘192.168.2.3’ also. You’ll need to change the IP NOTE IP address will be reset to default valueaddress setting of your computer if the IP address of your computer does not begin with ‘192.168.2’EU Countries Intended for Use SafetyR&TTE Compliance Statement EU Countries not intended for use