JVC GR-D90 How to handle a CD-ROM, For Your Maintenance, After Use, Cleaning The Camcorder

Page 43

How to handle a CD-ROM

Take care not to soil or scratch the mirror surface (opposite to the printed surface). Do not write anything or put a sticker on either the front or back surface. If the CD-ROM gets dirty, gently wipe it with a soft cloth outward from the center hole using a circular motion.

Do not use conventional disc cleaners or cleaning spray.

Do not bend the CD-ROM or touch its mirror surface.

Do not store your CD-ROM in a dusty, hot or humid environment. Keep it away from direct sunlight.

About moisture condensation . . .

You have observed that pouring a cold liquid into a glass will cause drops of water to form on the glass outer surface. This same phenomenon occurs on the head drum of a camcorder when it is moved from a cool place to a warm place, after heating a cold room, under extremely humid conditions or in a place directly subjected to the cool air from an air conditioner.

Moisture on the head drum can cause severe damage to the video tape, and can lead to internal damage to the camcorder itself.

For Your Maintenance

1)After Use

1.Turn off the camcorder.

2.Slide and hold OPEN/EJECT W in the direction of the arrow, then pull the cassette holder cover open until it locks. The cassette holder opens automatically. Remove the cassette.

3.Press “PUSH HERE” to close the cassette holder.

Once the cassette holder is closed, it recedes automatically. Wait until it recedes completely before closing the cassette holder cover.

4.Tilt the viewfinder upward. Press BATT. RELEASE Q and remove the battery pack.

2)Cleaning The Camcorder

1.To clean the exterior, wipe gently with a soft cloth. Put the cloth in diluted mild soap and wring it well to wipe off heavy dirt. Then wipe again with a dry cloth.

2.Open the LCD monitor. Wipe gently with a soft cloth. Be careful not to damage the monitor. Close the LCD monitor.

3.To clean the lens, blow it with a blower brush, then wipe gently with lens cleaning paper.

Serious malfunctioning

If malfunctioning occurs, stop using the unit immediately and consult your local JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery pack, AC Adapter, etc.) and wait a few minutes and then re-connect it and proceed as usual from the beginning.

NOTES:

Avoid using strong cleaning agents such as benzine or alcohol.

Cleaning should be done only after the battery pack has been removed or other power units have been disconnected.

Mold may form if the lens is left dirty.

When using a cleaner or chemically treated cloth refer to the cautions of each product.

EN

CAUTIONS 43

Image 43
Contents GR-D90 GR-D70 GR-D30 Contents Safety Precautions Before recording an important scene Important Product Safety InstructionsMake sure the arrow is Pointing upward Core FilterWind once StopperSub Menu Using AC Power PowerCharging the Battery Pack Using the Battery PackAbout Batteries Grip AdjustmentViewfinder Adjustment Lithium-ion is vulnerable in colder temperaturesLoading/Unloading a Cassette Approximate recording time Tape Recording modeShoulder Strap Attachment Tripod MountingScreen closes Date/Time SettingsRecording Mode Setting RETURN, and press it twice. The Menu Screen closesDisplay Loading a Memory Card Picture Quality/Image Size SettingTo Unload a Memory Card Label Clipped edge Memory cardBasic Recording To Adjust The Brightness Of The DisplayTape Recording Self-Recording Operation ModePower-Linked Operation Journalistic ShootingRecording from the Middle of a Tape To Control The Speaker VolumeTime Code Normal PlaybackPress To cancel Blank Search midwayBlank Search Press Blank SearchConnections If using a VCR . . . go to step If not . . . go to stepDate/Time Set DATE/TIME to AUTO, on or OFF To Protect Valuable Files available only for SD Memory Card Basic Shooting SnapshotTo Delete Unwanted Still Images To Remove The Shutter SoundEN Memory Card Recording Approximate Number of Storable ImagesMultiMediaCard To Magnify The Stored ImagesRemoving On-Screen Display Auto PlaybackViewing File Information Index PlaybackProtecting Files Deleting Files EN Advanced FeaturesTo Remove Protection To Print ALL Still Images ONE Print for Each Setting Print Information Dpof SettingAdvanced Features EN Dubbing Still Images Recorded On a Tape To a Memory CardFolder and File names To Reset The No. Of PrintsMaking a New Folder Initializing a Memory CardProgram AE With Special Effects Night-AliveFade/Wipe Effects Auto Focus Snapshot Mode SelectionSnapshot For Tape Recording Snapshot RecordingTo Brighten The Subject Quickly Manual FocusExposure Control To Return To Automatic Exposure ControlIris Lock White Balance AdjustmentManual White Balance Operation Balance WIPE/FADERProgram AE ExposureSystem ManualCamera Display Quality , Image Size For Playback MenuVideo Clock ADJPlayback Sound 12BIT ModeVideo Display DisplayDubbing Dubbing To Or From a VCRTo Use This Camcorder As a Player To Use This Camcorder As a RecorderDV cable Optional Core filter To DV To DV @ Core filterPlayback Special Effects Using the Remote Control Unit ENSlow-Motion Playback Frame-By-Frame PlaybackInsert Editing Set 12BIT Mode to Sound 2 or MIX Menu Screen  pgEN Using the Remote Control Unit Audio DubbingConnection To a Personal Computer Using USB cable GR-D90/D70 onlyUsing DV cable Using USB cable B Using DV cable GR-D90/D70 onlyImage taken using Snapshot is too dark No power is suppliedFocus does not adjust automatically Snapshot mode cannot be usedDate/time does not appear Indicators and the image color on LCD monitor are not clearBlack & White Fader does not work White Balance cannot be activatedMemory card cannot be played back Charger indicator on the camcorder does Not lightAn error indication E01, E02 or E06 appears An error indication E03 or E04 appearsCassettes Using Household AC Plug AdapterBattery Packs AC AdapterMain Unit LCD MonitorAfter Use How to handle a CD-ROMFor Your Maintenance Cleaning The CamcorderTelephone Number Trade NameResponsible party AddressDigital Video Camera ConnectorsCamcorder GeneralIndex Controls, Connectors And IndicatorsLCD monitor Speaker Viewfinder Battery Release Button BATT. Release .... pg VIDEO/DSC Switch VIDEO, DSC GR-D90/D70 onlyFast-Forward Button USB Universal Serial Bus Connector Power Switch1024 During Both Tape And Memory Card Recording LCD Monitor/Viewfinder IndicationsDuring Memory Card Recording Only GR-D90/D70 only During Memory Card Playback GR-D90/D70 onlyAppears when the focus is adjusted manually Appears when in the Squeeze or Cinema modeDisplays the sound mode for approx seconds Appears when Digital Image Stabilizer DIS isHigh E03 or E04 Unit in Safeguard Mode Eject E01, E02 or E06 Unit in Safeguard ModeAppears if a file in another format is selected Terms Unload a Tape VIDEO/DSC Switch PositionRecord-Standby SD Memory CardMemo Memo US 1102-HO-UN-PJ