JVC TK-C1480 manual Motion Detect Screen Communication Screen

MENU SETTING

MOTION DETECT Screen(Continued)

COMMUNICATION Screen

Item

Functions and set values

Initial value

Settings are made for the control signal-connecting terminals on the back. If the setting is changed, be absolutely sure to switch on the power again.

LEVEL

AREA EDIT

This sets the level that detects motion. If the item MODE is set to OFF, “- - -” will appear, and settings cannot be changed. To function with large signal level change…decrease the value To function with small signal level change…increase the value [Set values: –5 to NORMAL to 5]

This sets the range in which the motion detecting function works. ( Page 37)

NORMAL

–

Item

STYLE

MACHINE ID

Functions and set values	Initial value
This sets a communication system according to the	P TO P
system used.
P TO P (Point to point)
This is set when a remote control unit controls a camera.
M.DROP (Multi-drop)
This is set when a remote control unit controls a plural
number of cameras.
This is set when the STYLE item is set to M.DROP. This	– – –
is the number that identifies individual cameras in a group.
No proper function can be realized if an ID number is

ALARM TIME

This sets the output time of the alarm signal output of	10s
AUX terminal as well as “ALARM” display on the screen
when motion is detected.
If the item MODE is set to OFF, “- - -” will appear, and
settings cannot be changed.
[Set values: OFF, 5s, 6s, 7s, 8s, 9s, 10s, 15s, 20s, 30s,
1min]
MEMO
When the MODE item is set to OFF, only the alarm signal
of the AUX terminal is output, and “ALARM” is not
displayed on the screen.

repeated within a system.

Acombined use with the RM-P2580 necessitates the setting together with the video input number of the RM- P2580.

If the item STYLE is set to P TO P, “- - -” will appear, and settings cannot be changed.

[Set values: 1 to 99]

FACTORY SETTINGS Screen

DEMONSTRATION	This is used when checking and confirming the set motion	–
	detecting function. The detection area is shown in gray.
	( Page 37)

Set values are returned to initial values.
Item		Functions and set values		Initial value
FACTORY	The values set on the menu are returned to initial values.			–
SETTINGS	CANCEL	:	No return to the initial value.
	CLEAR	:	Returns set values except titles to the
	(WITHOUT TITLE)		initial value.
	CLEAR (ALL)	:	Returns all set values including titles
			to the initial value.
	Select respective set value and press the SET button.
	Then, “DATA CLEARED” will appear for about 3 seconds.
	Be sure not to switch off the power while the display is
	still on.
	MEMO
	However, when making settings by means of transmitted
	commands, the contents of the COMMUNICATION menu
	do not return to the factory settings.

E-32 E-33