JVC TK-C1480 manual Controls, Connectors and Indicators, Set

INTRODUCTION

Controls, Connectors and Indicators

2

! @# $

1 3

4 5

SET

AWC

MENU

CAMERA			%
			^
SETUP	EXT TERM-OFF	ON
	INT/GL	LL	&
	DUPLEX	SIMPLEX
	RX TERM-OFF	ON	*
	NOT USED

VIDEO

IRIS

DC

			7		6
1	Lens mount			4	Camera-mounting bracket
	This means to attach the lens.				The bracket has been attached on the
	This is applicable to both the C-mount				bottom of the camera before shipment. It
	lenses and CS-mount lenses.				can also be attached on the top
2	Backfocus adjustment ring				according to the circumstance.
					To re-attach the bracket use the threaded
	Adjusting the back focus during lens
					holes at the top, with the camera
	installation.
					mounting bracket locking screws 7 .
	When readjustment is required, loosen
	the locking screw	3	by turning it	5	Camera-mounting screw hole (1/4
	counterclockwise and turn the back focus				inch)
	adjustment ring 2 .				Use this hole when mounting
	After the adjustment, tighten the locking				the camera onto a fixer, pan/	MAX.
	screw 3 again.				tilt unit, and the like. (Use a
						7mm
3	[BF LOCK] Back focus locking screw				screw shorter than 7 mm.)
					Rotation-preventive hole
	This serves to fix the back focus-adjusting			6
	ring.				Make use of this rotation-preventive hole
					to prevent any fall when mounting the
					camera. Make sure that the camera is
					securely mounted.
				7	Camera mounting bracket fixing screws
					(⋅2: M2.6 ⋅ 6 mm)
					Be sure to use a 6 mm long screw.

				8
8	Cover
	The cover opens if it is pulled to the left
	while being pushed.
9	[VIDEO/DC] Iris Selector Switch
	This is set according to the type of lens
	when an automatic iris control lens is
	used.
	VIDEO: In case of lens with EE amp built-
			in.
	DC:		In case of lens without EE amp
	(		built-in.	)
		At time of factory shipment
		VIDEO: TK-C1480E and TK-C1481EG
		DC:	TK-C1480U
10	[IRIS] Iris Terminal
	This is connected to an automatic iris
	control lens.
	( Page 15)
11	[MENU] Menu Button
	When the button is pressed, a menu

9 0
	screen is brought up.
	( Page 23)
12	[SET/AWC] Set. Auto White Control
	Button
	SET:	Press this button to display a sub-
		menu.
		( Page 23)
	AWC: If this button is kept pressed for
		more than 1 second, a one-push-
		auto-white-balance function works
		and sets the white balance. Once
		it is set, even if colour temperature
		changes, white balance does not
		change. It is also possible to make
		fine adjustments on the set white
		balance.
		( Page 22)

E-8 E-9