VIDEO/MEMORY Switch
To DV
IN/OUT
| Lock | MANUAL |
|
| |
| Button | AUTO |
|
| |
Core filter |
| OFF |
| PLAY | |
|
| Power Switch |
DV cable |
|
|
(optional) |
|
|
Core filter
To DV IN
Video unit equipped with
DV input connector
EN 51
Dubbing To A Video Unit Equipped With A DV Connector (Digital Dubbing)
It is also possible to copy recorded scenes from this camcorder onto another video unit equipped with a DV connector. Since a digital signal is sent, there is little if any image or sound deterioration.
[To use this camcorder as a player]
1 Make sure all units are turned off. Connect this camcorder to a video unit equipped with a DV input connector using a DV cable as shown in the illustration.
2 Set this camcorder’s VIDEO/MEMORY Switch to “VIDEO”, then the Power Switch to “PLAY” while pressing down the Lock Button located on the switch, turn on the video unit’s power, and insert the appropriate cassettes in this camcorder and the video unit.
3 Engage the video unit’s
4 Engage this camcorder’s Play mode to find a spot just before the
5 Press 4/6 on this camcorder and engage the video unit’s Record mode.
6 Engage the video unit’s
7 Repeat steps 4 through 6 for additional editing, then stop the video unit and this camcorder when finished.
NOTES:
●It is recommended to use the AC Adapter as the power supply instead of the battery pack ( pg. 9).
●If the remote control is used when both the player and recorder are JVC video units, both units will perform the same operation. To prevent this from happening, press the buttons on both units.
●If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed.
●Even though the DV cable is connected correctly, sometimes the image may not appear in step 5. If this occurs, turn off the power and make connections again.
●If “Playback Zoom”( pg. 57), “Playback Special Effects” ( pg. 56) or “Snapshot” is attempted during playback, only the original playback image recorded on the tape is output from the DV IN/OUT connector.
●When using a DV cable, be sure to use the optional JVC