52 EN | DUBBING (cont.) |
VIDEO/MEMORY Switch
Dubbing From A Video Unit Equipped With A DV Connector (Digital Dubbing)
[To use this camcorder as a recorder]
1 Make sure all units are turned off. Connect this camcorder to a video unit equipped with a DV output connector using a DV cable as shown in the illustration.
To DV
IN/OUT
Lock Button
Core filter 
DV cable (optional)
Core filter
MANUAL
AUTO
OFF
PLAY
Power Switch
2 Set this camcorder’s VIDEO/MEMORY Switch to “VIDEO”, then the Power Switch to “PLAY” while pressing down the Lock Button located on the switch. Turn on the video unit’s power and insert the appropriate cassettes in this camcorder and the video unit.
3 Set “REC MODE” to “SP” or “LP” in the Menu Screen depending on your preference ( pg. 48).
4 Press the Recording Start/Stop Button on this camcorder to engage the
DV. IN ” appears on the screen.
5 Engage the video unit’s Play mode, then engage the Still Playback mode when you have found a spot just before the
To DV OUT
Video unit equipped with
DV output connector
NOTES:
6 Press the Recording Start/Stop Button on this
camcorder to engage the Record mode. rotates on the screen. Engage the video unit’s Play mode.
7 To stop dubbing, press the Recording Star/Stop
Button on this camcorder so that stops rotating, then engage the video unit’s Stop mode.
8 Repeat steps 5 through 7 for additional editing.
●It is recommended to use the AC Adapter as the power supply instead of the battery pack ( pg. 9).
●If the remote control is used when both the player and recorder are JVC video units, both units will perform the same operation. To prevent this from happening, press the buttons on both units.
●If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed.
●Even though the DV cable is connected correctly, sometimes the image may not appear in step 5. If this occurs, turn off the power and make connections again.
●When using a DV cable, be sure to use the optional JVC
●Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current “SOUND MODE” setting ( pg. 45).
●During Digital Dubbing, no signals are output from the video or audio connectors.