JVC TK-C676 manual Camera Function Screen

Item

Function & Setting

Initial Value

V. PHASE

This adjusts the vertical synchronization to those of other cameras when a selector

0

switch for the synchronizing system on the Ceilling Mount is at LL. (50 Hz power

region only.)

When it is not set to LL, “---” will appear, disabling change the set value.

Setting values : –156 to 0 to 156

POS.TITLE LOC.

Sets the location of the position title and area title in the monitor.

UP-L

UP

: At the top of the screen.

DOWN

: At the bottom of the screen.

L

: In the left half of the screen.

C

: In the center of the screen.

R

: In the right half of the screen

Setting values : UP-L, UP-C, UP-R, DOWN-L, DOWN-C, DOWN-R

FLIP

When a tilting operation is started while this item is OFF, the camera will stop at the

DIGITAL

position where it is pointing straight downwards. When an object moves directly

below the camera, the camera makes three movements 1points the straight down-

ward 2 pans 180° 3 points upwards.

The FLIP function makes it possible to reduce these operations. Use this function

when monitoring an object passing directly below the camera.

OFF

: Turns the FLIP function off.

DIGITAL : Once the camera reaches a tilt of 135 degrees from horizontal after

passing a position facing directly downwards, a picture is inverted both

AUTO

vertically and horizontally.

: When the camera reaches a position facing directly downwards, it pans

by 180° then stops.

VAR. P/T SPEED

Under this function, the panning and tilting speeds are adjusted automatically rela-

ON

tive to the zoom ratio of the lens. Setting the zoom lens towards TELE decreases

the pan and tilting speeds.

Setting the zoom lens towards WIDE end increases the pan and tilting speeds.

Use this function when monitoring objects at differing zoom ratios.

OFF : Turns this function off.

ON : Turns this function on.

EASY AF

When this item is set to ON, the auto focusing (AF) is activated automatically dur-

OFF

ing manual pan/tilt and zoom operations.

This function is convenient when frequent manual operations are expected as it

eliminates the need to focus manually after every manual operation.

OFF : Turns this function off.

ON : Turns this function on.

MEMO

Auto focusing may sometimes be incapable of bringing certain objects into accurate focus.

(☞ P. 4)

In this case, use the manual focusing facility.

D. ZOOM MAX

When the zoom lens is set toward TELE, optical zooming is activated first and

x2

electronic zooming second. This function sets the maximum zoom ratio of the

electronic zooming.

Setting values : x1, x2, x4, x6, x8, x10.

MEMO

● Note Picture quality deteriorates under electronic zooming as it is accompanied by digital

image processing.

● An increase in the electronic zooming ratio may deviate the center of the image slightly

toward the top left. This is due to the camera properties and is not a malfunction.

● Continuous operation from optical zooming to electronic zooming is not available. When

optical zooming reaches the TELE end, press the TELE button again.

PRIVATE MASK..

This function grays out sections that are not to be displayed in the monitored pic-

–

ture area.

The grayed out section moves accordingly when the camera is panned, tilted or

when the zoom is adjusted.

☞ P.29, “PRIVATE MASK Setup”