JVC GR-DVL210 specifications Indications Function

62 EN				INDEX Indications (cont.)
	Warning Indications
	Indications		Function
		Displays the battery remaining power.
		Remaining power level: high
		Remaining power level: exhausted
		As the battery power comes close to nil, the battery indicator				blinks.
		When the battery power is exhausted, power turns off automatically.
		Appears when no tape is loaded.			( pg. 11)
	CHECK TAPE’S ERASE	Appears when the erase protection tab is set to “SAVE” while the Power
	PROTECTION TAB	Switch is set to “ ” or “ ”.			( pg. 11)
		Appears if dirt is detected on the heads during recording. Use an optional
	HEAD CLEANING	cleaning cassette.			( pg. 64)
	REQUIRED USE
	CLEANING CASSETTE
		Appears if condensation occurs. When this indication is displayed, wait
	CONDENSATION	more than 1 hour until condensation disappears.
	OPERATION PAUSED
	PLEASE WAIT
	TAPE!	Appears if a tape is not loaded when the Recording Start/Stop Button or
		SNAPSHOT Button is pressed while the Power Switch is set to “			” or “ ”.
	TAPE END	Appears when the tape ends during recording or playback.			( pg. 51)
	DIFFERENT	Appears if a tape in another format is loaded.
	FORMATTED TAPE
		● Appears when the date/time is not set.			( pg. 10)
	SET DATE/TIME!	● Appears when the built-in clock battery runs out and the previously set
		date/time is erased. Consult your nearest JVC dealer for replacement.
	LENS CAP	Appears for 5 seconds after power is turned on if the lens cap is attached.
	A. DUB ERROR!	Appears if Audio Dubbing is attempted on a blank portion of a tape.
					( pg. 47)
	A. DUB ERROR!	● Appears if Audio Dubbing is attempted on a tape recorded in the LP
	<CANNOT DUB	mode.			( pg. 47)
	ON A LP RECORDED	● Appears if Audio Dubbing is attempted on a tape recorded in 16-bit
	TAPE>
		audio.			( pg. 47)
	<CANNOT DUB
		● Appears if A. DUB (e) on the remote control is pressed when the erase
	ON A 16BIT
		protection tab is set to “SAVE”.			( pg. 47)
	RECORDING>
	<CHECK TAPE’S ERASE
	PROTECTION TAB>
	E01 — E06	The error indications (E01 — E06) show what type of malfunction has
		occured. When an error indication appears, the camcorder turns off
	UNIT IN SAFEGUARD
		automatically. Remove the power supply (battery, etc.) and wait a few
	MODE REMOVE AND
	REATTACH BATTERY	minutes for the indication to clear. When it does, you can resume using the
		camcorder. If the indication remains, consult your nearest JVC dealer.