JVC GR-DVL210 specifications Details, Power,
pg

DETAILS

EN51

I T E M S

N O T E S

➪ Power

❍ Perform charging where the temperature is between 10°C and 35°C

(
pg. 7)

(50°F and 95°F). 20°C to 25°C (68°F to 77°F) is the ideal

temperature range for charging. If the environment is too cold,

charging may be incomplete.

❍ Charging times are for a fully discharged battery pack.

❍ Charging time varies according to the ambient temperature and the

status of the battery pack.

❍ To avoid interference with reception, do not use the AC Adapter

near a radio.

❍ Since the AC Adapter processes electricity internally, it becomes

warm during use. Be sure to use it only in well-ventilated areas.

❍ The following operation stops charging:

• Set the Power Switch to “

”, “ ” or “

”.

• Disconnect the AC adapter from the camcorder.

• Unplug the AC adapter from the AC outlet.

• Detach the battery from the camcorder.

➪ BASIC

❍ When you use the LCD monitor outdoors in direct sunlight, the

RECORDING

LCD monitor may be difficult to see. If this happens, use the

(
pg. 14, 15)

viewfinder instead.

❍ The cassette holder cannot be opened unless a power supply is

attached.

❍ There may be a delay after you open the cassette holder cover until

the cassette holder opens. Do not use force.

❍ Once the cassette holder is closed, it recedes automatically. Wait

until it recedes completely before closing the cassette holder cover.

❍ When the Recording Start/Stop button is pressed, it may take a few

seconds before actual recording starts. “

” starts rotating when

the camcorder actually starts recording.

❍ The time required to calculate and display the remaining tape

length, and the accuracy of the calculation, may vary according to

the type of tape used.

❍ “TAPE END” appears when the tape reaches its end, and the power

goes off automatically if left in this condition for 5 minutes. “TAPE

END” also appears when a cassette at its end is loaded.