JVC GR-DVL30 specifications EN49, Corrective Action, Tape END appears Position except, Bright

Page 49

TROUBLESHOOTING

EN49

If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery pack, AC Power Adapter/Battery Charger, etc.) and wait a few minutes; and then re-connect it and proceed as usual from the beginning.

 

SYMPTOM

 

 

POSSIBLE CAUSES

 

CORRECTIVE ACTION

1.

No power is supplied.

 

1. •The power is not connected

 

1. •Connect the AC Power

 

 

 

properly.

 

Adapter/Charger securely

 

 

 

•The battery is dead.

 

(☞ pg. 7).

 

 

 

 

 

 

 

•Replace the dead battery

 

 

 

 

 

 

with a fully charged one

 

 

 

 

 

 

(☞ pg. 6, 7).

 

 

 

 

 

 

 

2.

“SET DATE/TIME!”

 

2. •The built-in clock’s

 

2. •Connect the camcorder to

 

appears.

 

rechargeable lithium battery

 

an AC outlet using the AC

 

 

 

is discharged.

 

Power Adapter/Charger for

 

 

 

•The previously set date/time

 

over 24 hours to charge the

 

 

 

is erased.

 

clock’s lithium battery

 

 

 

 

 

 

 

(☞ pg. 8).

 

 

 

 

 

 

 

 

3.

Recording cannot be

 

3. •The tape’s erase protection

 

3. •Set the tape’s erase

 

 

performed.

 

switch is set to “SAVE”.

 

protection switch to “REC”

 

 

 

•The Power Switch is set to

 

(☞ pg. 9).

 

 

 

 

“

”.

 

•Set the Power Switch to any

 

 

 

•“TAPE END” appears.

 

position except “

” or

 

 

 

•The cassette’s cover is open.

 

“OFF” (☞ pg. 13).

 

 

 

 

 

 

 

•Replace with new cassette

 

 

 

 

 

 

(☞ pg. 9).

 

 

 

 

 

 

 

•Close the cassette’s cover.

 

 

 

 

 

 

4.

There is no picture.

 

4. •The camcorder is not getting

 

4. •Turn the camcorder’s power

 

 

 

power, or some other

 

off and on again

 

 

 

 

malfunction exists.

 

(☞ pg. 12).

 

 

 

 

 

 

5. Some functions are not

 

5. •The Power Switch is set to

 

5. •Set the Power Switch to

 

available using MENU/

 

“

”.

 

“ ” (☞ pg. 13).

 

 

BRIGHT.

 

 

 

 

 

 

 

 

 

 

 

 

6. The focus does not adjust

 

6. •Focus is set to “MANUAL”.

 

6. •Set Focus to “AUTO”

 

 

automatically.

 

•The recording was done in a

 

(☞ pg. 25).

 

 

 

 

dark place, or the contrast

 

•Clean the lens and check

 

 

 

was low.

 

the focus again (☞ pg. 54).

 

 

 

•The lens is dirty or covered

 

 

 

 

 

 

with condensation.

 

 

 

 

 

 

 

 

7. The cassette will not load

 

7. •The cassette is in the wrong

 

7. •Set it in the right position

 

properly.

 

position.

 

(☞ pg. 9).

 

 

 

 

•The battery’s charge is low.

 

•Install a fully charged

 

 

 

 

 

 

 

battery (☞ pg. 6, 7).

 

 

 

 

 

 

8. Snapshot mode cannot be

 

8. •The Squeeze mode is

 

8. •Disengage the Squeeze

 

used.

 

selected.

 

mode (☞ pg. 19).

 

 

 

 

 

 

9. The Snapshot colour looks

 

9. •The light source or the

 

9. •Find a white subject and

 

strange.

 

subject does not include

 

compose your shot so that it

 

 

 

white. Or there are various

 

also appears in the frame

 

 

 

different light sources

 

(☞ pg. 17).

 

 

 

 

behind the subject.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CONTINUED ON NEXT PAGE

Page 48 Page 50
Image 49
Page 48 Page 50
Contents GR-DVL40 GR-DVL30 GR-DVL20 It is recommended that you Dear CustomerConnection to the mains supply in the United Kingdom Above ALL EN3Safety Precautions Lithium Battery CR2025 for remote control unit Battery Pack How to Attach The Core FilterRelease Charging the Battery Pack PowerLithium-ion is vulnerable in colder temperatures About BatteriesUsing AC Power Using the Battery PackTo Detach The Battery Pack EN7Built-in Clock’s Rechargeable Lithium Battery Date/Time SettingsEN9 Loading/Unloading a CassetteEN Getting Started Recording Mode SettingViewfinder Adjustment Grip AdjustmentShoulder Strap Attachment Tripod Mounting12 EN To Adjust The Brightness Of The DisplayBasic Recording Shooting While Watching ViewfinderEN13 Power Switch PositionJournalistic Shooting SELF-RECORDINGSlide the Power Zoom Lever towards W Slide the Power Zoom Lever towards T14 EN ZoomTo brighten the scene when natural lighting is too dim Feature Video Light GR-DVL40/ DVL30 onlyEN15 Set Light OFF/AUTO/ON as required16 EN When a blank portion is recorded on a tapeProper recording ShootingMotor Drive Mode Recording Advanced FeaturesSnapshot Snapshot RecordingUsing Menus For Detailed Adjustment Advanced FeaturesRecording Menu Explanations Mode Menu ExplanationsOn Next Date/Time Menu Explanations Factory presetSystem Menu Explanations Before the following steps, perform steps 1 through 4 above LCD Monitor/Viewfinder IndicationsFade/Wipe Effects 22 ENPicture Wipe or Dissolve Selection If you select Picture Wipe/Dissolve during recordingFader And Wipe Menu EN23Menu Programme AE With Special Effects 24 ENEN25 FocusingAuto Focus Manual FocusExposure Control 26 ENTo Return To Automatic Exposure Control EN27 Iris LockIris To Return To Automatic Iris ControlManual White Balance Operation White Balance AdjustmentTo Return To Automatic White Balance To Change The Tint For RecordingTo Control The Speaker Volume Load a tape pg Set the Power Switch toAvailable only with the RM-V711U remote control provided pg Basic PlaybackPlayback Menu allows you to set the following functions Playback MenuDisplay Displaying the Date During Playback Playback SoundEN31 Time Code Displaying The Time Code During PlaybackBasic Connections 32 ENEN33 If using a VCR . . . go to step If not . . . go to step34 EN When connecting cables, open this coverPlayback Advanced Connections Connection To a Personal ComputerEN35 Connection To a Video Unit Equipped With a DV ConnectorMake sure all units are turned off Set the Power Switch back to Connect when the S-Video cable is not used36 EN Tape DubbingEN37 Digital Dubbing38EN Installing The BatteryFunctions Buttons EN39Feature Frame-By-Frame Playback Feature Slow-Motion PlaybackFeature Playback Zoom EN41 Feature Playback Special EffectsTo allow you to add creative effects to the playback image 42 EN Create edited videos easily using your camcorder asSET REMOTE/VCR Code You are now ready to try Random Assemble EditingEN43 JVC VCR equipped with a remote pause connectorMake Connections Select ScenesSelect Scenes 44 ENAutomatic Editing to VCR EN45Not start editing For More Accurate Editing 46 ENDiagnosing VCR/CAMCORDER Timing Recording deckEN47 Adjustment of VCR/CAMCORDER TimingAudio Dubbing 48 ENCorrective Action EN49Tape END appears Position except Bright50 EN Even when Slow Shutter is Mode is set to OFFIndicators disappear Date/Time Menu Scene transition does not52 EN Corrective Action After Use Cleaning The CamcorderTurn off the camcorder EN55 To prevent damage and prolong service lifeTo avoid hazard Do not burn56 EN About moisture condensation EN57Serious malfunctioning E 0 Q 9 W 58ENEN59 60 EN Displays the operation mode positionIndications FunctionEN61 LCD Monitor/Viewfinder Indications During PlaybackIndications Function Function62 EN Connectors AC Power Adapter/Charger AA-V20EG or AA-V20EKCamcorder EN63GR-DVL20

GR-DVL30 specifications

The JVC GR-DVL30 is a compact digital video camcorder that was introduced in the early 2000s, aimed at both amateur filmmakers and enthusiasts who wanted to capture high-quality videos with ease. This camcorder offers a blend of advanced features, intuitive design, and innovative technology, making it a popular choice for users seeking portability without compromising video quality.

One of the standout features of the GR-DVL30 is its 1/4-inch progressive scan CCD sensor, which allows for clear and vibrant image reproduction. With a maximum resolution of 800,000 pixels, this camcorder is capable of capturing stunning footage in various lighting conditions. The device supports both 16:9 wide and 4:3 standard aspect ratios, providing users with flexibility in how their videos are framed and displayed.

In terms of zoom capabilities, the GR-DVL30 features a powerful 10x optical zoom lens, complemented by a 100x digital zoom. This combination allows users to capture distant subjects with impressive clarity, making it ideal for events such as sports or wildlife observation. The lens also includes a built-in optical image stabilization system, which significantly reduces the effects of shake and vibrations, providing smooth, jitter-free video.

The camcorder incorporates advanced digital effects and transitions, giving users the ability to add creative touches to their footage. Some of these effects include night vision mode, slow motion, and various digital filters that enhance the overall viewing experience. Additionally, the 2.5-inch LCD display allows users to easily review their recordings and navigate the camcorder's menu system with convenience.

Connectivity is another highlight of the JVC GR-DVL30, with options including FireWire and USB ports for easy transfer of videos to a computer. This is particularly useful for editing and sharing videos online. The device also features an AV output, enabling users to connect the camcorder to a TV for immediate playback of their recorded media.

Overall, the JVC GR-DVL30 is a versatile and user-friendly camcorder that embodies the perfect balance between functionality and portability. Its robust set of features and solid performance make it an excellent choice for video enthusiasts who want to document their lives and adventures in high quality. Whether for personal memories or creative projects, the GR-DVL30 remains a noteworthy option in the realm of handheld camcorders.
Top Page Image Contents