JVC GR-DVL30 specifications 12 EN, Basic Recording, Shooting While Watching Viewfinder

12EN

RECORDING

BasicRecording

Recording

Start/Stop Button

Power Switch

Display

25 min

During shooting

Tape remaining time indicator (Approximate)

min 90 min 89 min 3 min (Now calculating)

0min 1 min 2 min

(Blinking) (Blinking) (Blinking)

Shooting While Watching The

Viewfinder

NOTE:

You should already have performed the procedures listed below. If not, do so before continuing.

●Power (☞ pg. 6)

●Load A Cassette (☞ pg. 9)

●Recording Mode Setting (☞ pg. 10)

●Grip Adjustment (☞ pg. 11)

●Viewfinder Adjustment (☞ pg. 11)

1 Make sure the LCD monitor is closed and locked. Press in the tabs on the lens cap to remove it, then set the Power Switch to “” or “ ”. The power lamp lights and the camcorder enters the Record-Standby mode. “PAUSE” is displayed in the viewfinder.

2 Press the Recording Start/Stop Button. “” appears

in the viewfinder while recording is in progress.

3 Press the Recording Start/Stop Button again to stop recording. The camcorder re-enters the Record- Standby mode.

180° 90°MENU/

BRIGHT Dial

Shooting While Watching The LCD Monitor

BRIGHT – – – – –6– – – – –

Power Switch

Recording Start/Stop

Button

Before the following steps, perform the procedures listed in the above note.

1 Make sure the LCD monitor is fully open. Press in the tabs on the lens cap to remove it, then set the Power Switch to “ ” or “ ”. The power lamp lights and the camcorder enters the Record-Standby mode.

“PAUSE” is displayed in the LCD monitor.

2 Tilt the LCD monitor upward/downward for best viewability and press the Recording Start/Stop Button. “” appears in the LCD monitor while recording is in progress.

To Adjust The Brightness Of The Display

.... rotate MENU/BRIGHT until the brightness

indicator on the display moves and the appropriate brightness is reached.

•If you are using the GR-DVL40, it is also possible to adjust the brightness of the viewfinder.

3 Press the Recording Start/Stop Button again to stop recording. The camcorder re-enters the Record- Standby mode.

NOTE:

When you use the LCD monitor outdoors in direct sunlight, the LCD monitor may be difficult to see. If this happens, use the viewfinder instead.