JVC GR-DVL30 specifications After Use, Cleaning The Camcorder, Turn off the camcorder

To clean the lens, blow it with a blower brush, then wipe gently with lens cleaning paper.

54ENUSERMAINTENANCE

After Use

1 Turn off the camcorder.

2 Press PUSH OPEN and open the LCD monitor. Slide OPEN/EJECT in the direction of the arrow, then swing the cassette cover open until it locks. The cassette holder opens automatically.

Remove the cassette.

3 Press “PUSH HERE” to close the cassette holder, then close the cassette cover.

4 Close and lock the LCD monitor.

5 Slide BATTERY RELEASE and remove the battery pack.

6 Replace the lens cap over the lens.

OPEN/EJECT Switch

PUSH HERE

PUSH OPEN Button

Remove.

Cassette holder

BATTERY RELEASE Switch

Cleaning The Camcorder

1 To clean the exterior, wipe gently with a soft cloth.

Put the cloth in diluted mild soap and wring it well to wipe off heavy dirt. Then wipe again with a dry cloth.

2 Open the LCD monitor and wipe gently with a soft cloth. Be careful not to damage the monitor. Close the LCD monitor.

3

4 To clean the viewfinder, raise it to the vertical position. Carefully lift the plastic tab on the bottom of the viewfinder, and open the cover

1.

5 Insert a lens blower or soft cloth into the gap at the bottom of the viewfinder and clean the interior of the viewfinder with it 2.

6 Replace the lens cap, making sure it locks in place. Tilt the viewfinder back to the horizontal position.

NOTES:

●Avoid using strong cleaning agents such as benzine or alcohol.

●Cleaning should be done only after the battery pack has been removed or other power units have been disconnected.

●Mould may form if the lens is left dirty.

●When using a cleaner or chemically treated cloth refer to the cautions of each product.

Bottom of viewfinder

Blower brush

2

1

Cover