56 EN, Select Scenes | JVC GR-DVL505, GR-DVL805 instruction

If using a Fade/Wipe at the end of the scene, press FADE/WIPE.

•Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.

•If you select a Fade/Wipe effect for an Edit-Out point, the effect is automatically applied to the following Edit-In point.

•You cannot use a Picture Wipe/Dissolve at the end of the last scene.

•When you use Fade/Wipe effects, that time is included in the total time (this does not apply to Picture Wipe/Dissolve).

If using Playback Special Effects, press EFFECT ( pg. 53).

56 EN

USING THE REMOTE CONTROL UNIT (cont.)

Program
		I N	OUT MODE	Random Assemble
	1	– – – – : – – ~		Editing Menu
	2		~	Editing Menu
3			~
4			~
5			~
6			~
7			~
8			~
		T I ME CODE – – : – –
		TOTAL	0 0 : 0 0

Remote sensor

SELECT SCENES

4 Point the remote control at the camcorder’s remote sensor. Press PLAY (4) and then press R.A.EDIT ON/ OFF on the remote control.

The Random Assemble Editing Menu appears.

5 If using a Fade/Wipe at the beginning of the scene, press FADE/WIPE on the remote control.

•Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.

•You cannot use a Picture Wipe/Dissolve at the beginning of Program 1.

6 At the beginning of the scene, press EDIT IN/OUT on the remote control. The Edit-In position appears in the Random Assemble Editing Menu.

7 At the end of the scene, press EDIT IN/OUT. The Edit-Out position appears in the Random Assemble Editing Menu.

FADE/WIPE

PLAY

EFFECT

EDIT IN/OUT R.A.EDIT ON/OFF

CANCEL

10 Repeat steps 6 through 9 to register additional scenes.

•To change previously registered points, press CANCEL on the remote control. The registered points disappear, one at a time, from the most recently registered point.

•If you are not using Fade/Wipe or Program AE with special effects, repeat steps 6 and 7 only.

NOTES:

●When choosing a scene, set Edit-In and Edit-Out points so that there is a relatively large difference between them.

●If the search time for an in-point exceeds 5 minutes, the recording deck’s Record-Standby mode will be canceled and editing will not take place.

●If there are blank portions before or after the Edit-In and Edit-Out points, a blue screen may be included in the edited version.

●Since time codes register time only as accurately as seconds, the time code total time may not match the total program time exactly.

●Turning off the camcorder’s power erases all registered Edit-In and Edit-Out points.

●If you select Sepia or Monotone mode from Program AE with special effects, you cannot use the Dissolve or Black & White Fader. In this case the Dissolve or Black & White indicator begins blinking. Once the next Edit-In point is registered, the effect is turned off. To combine these effects, use Sepia or Monotone during recording, then use the Dissolve or Black & White Fader during Random Assemble Editing.

●It is not possible to use Fade/Wipe effects and Program AE with special effects during Random Assemble Editing using a DV cable.