JVC GR-DVL505 Demonstration will resume, After viewing demo, set to OFF, High magnification

Page 26

26 EN RECORDING Advanced Features For Video And D.S.C. (cont.)

Menu Screen Explanations (cont.)

CAMERA MENU

MANUAL MENU

DEMO.

ON

Demonstrates certain functions such as Program AE with special effects, etc.,

MODE

 

and can be used to confirm how these functions operate. When “DEMO.

 

 

MODE” is set to “ON” and the Menu Screen is closed, demonstration starts.

 

 

Performing any operation during the demonstration stops the demonstration

 

 

temporarily. If no operation is performed for more than 1 minute after that,

 

 

the demonstration will resume.

 

 

NOTES:

 

 

If a tape is in the camcorder, the demonstration cannot be turned on.

 

 

“DEMO. MODE” remains “ON” even if the camcorder power is turned off.

 

 

If “DEMO. MODE” remains “ON”, some functions will not be available.

 

 

After viewing demo, set to “OFF”.

 

 

 

 

OFF

Automatic demonstration will not take place.

 

 

 

SIDE LED

ON

The Side LED indicator ( p. 74, 75) lights on the camcorder when the

 

 

Power Switch is set to “ ” or “ ”.

 

OFF

 

 

DIS

ON

To compensate for unstable images caused by camera-shake, particularly at

 

 

high magnification.

 

 

NOTES:

 

 

Accurate stabilization may not be possible if hand shake is excessive, or

 

 

under the following conditions:

 

 

•When shooting subjects with vertical or horizontal stripes.

 

OFF

•When shooting dark or dim subjects.

 

 

•When shooting subjects with excessive backlighting.

 

 

•When shooting scenes with movement in various directions.

 

 

•When shooting scenes with low-contrast backgrounds.

 

 

Switch off this mode when recording with the camcorder on a tripod.

 

 

The “ ” indicator blinks or goes out if the Stabilizer cannot be used.

TELE

ON

Usually the distance to a subject where the lens is in focus depends on the

MACRO

 

zoom magnification. Unless there is a distance more than 1m (3.3 ft.) to the

 

 

subject, the lens is out of focus at the maximum telephoto setting. When set

 

OFF

to “ON”, you can shoot a subject as large as possible at a distance of approx.

 

 

60 cm (2 ft.).

 

 

•Depending on the zoom position, the lens may go out of focus.

WIDE

OFF

Records with no change in the screen ratio. For playback on a TV with a

MODE

 

normal screen ratio.

 

 

 

CINEMA Inserts black bands at the top and bottom of the screen. During playback on wide-screen TVs, the black bands at the top and bottom of the screen are cut

and the screen ratio becomes 16:9. appears. When using this mode, refer to your wide-screen TV’s instruction manual. During playback/recording on 4:3 TVs/LCD monitor/viewfinder, black bands are inserted at the top and bottom of the screen and the image appears like a letterboxed 16:9 movie.

The “CINEMA” mode is effective only when the VIDEO/DSC Switch is set to “VIDEO”.

SQUEEZE For playback on TVs with an aspect ratio of 16:9. Naturally expands the image

to fit the screen without distortion. appears. When using this mode, refer to your wide-screen TV’s instruction manual. During playback/recording on 4:3 TVs/LCD monitor/viewfinder, the image is elongated vertically.

The “SQUEEZE” mode is effective only when the VIDEO/DSC Switch is set to “VIDEO”.

: Factory-preset

Image 26
Contents GR-DVL805 GR-DVL505 Dear Customer It is recommended that youPower Lines Power SourcesPower Cord Protection Grounding or PolarizationDamage Requiring Service AccessoriesCleaning Replacement PartsSafety Precautions Make sure you only use cassettes with the Mini DV markFor remote control unit AC Power Adapter/Charger Remote Control UnitAA-V40U RM-V716U AAA R03 Battery x Shoulder Strap Editing CableAutomatic Demonstration Lithium-ion is vulnerable in colder temperatures PowerCharging the Battery Pack About BatteriesTo Detach The Battery Pack Using the Battery PackUsing AC Power Approximate recording time10 EN Grip AdjustmentViewfinder Adjustment Shoulder Strap AttachmentDate/Time Settings EN1112 EN Loading/Unloading a CassetteEN13 Recording Mode SettingSet the tape recording mode depending on your preference During playback of a tape recorded on anotherPicture Quality Mode Setting 14 ENVIDEO/DSC Switch Position Operation ModePower Switch Position Manual EN1516 EN Power  pgTo Adjust The Brightness Of The Display Load a Cassette  pgSELF-RECORDING EN17Journalistic Shooting During recording, sound is not heard from the speaker18 EN Power Switch Snapshot For Video RecordingSnapshot Mode Selection Snapshot RecordingImage is stored in the camcorder’s built-in memory Basic Shooting SnapshotAvailable Snapshot modes are the same as those on pg To Delete Unwanted Still ImagesZoom Slide the Power Zoom Lever towards T20 EN Zoom OutProper recording When a blank portion is recorded on a tapeEN21 22 EN Feature Video LightTo brighten the scene when natural lighting is too dim Set Light OFF/AUTO/ON as requiredEN23 Feature Auto FocusFeature Manual Focus To obtain correct focusSee pg Go to stepMenu Screen Explanations EN25When shooting subjects with vertical or horizontal stripes Side LED indicator  p , 75 lights on the camcorder whenPower Switch is set to or When shooting dark or dim subjectsEN27 To Deactivate The Selected Effect Fade/Wipe EffectsPicture Wipe or Dissolve Selection Sound at the end of the last recorded scene is not storedMenu EN29Fader And Wipe Menu Slow Slow Shutter To Deactivate The Selected ModeProgram AE With Special Effects SlowEN31 Exposure ControlIris Lock To Return To Automatic White Balance White Balance AdjustmentManual White Balance Operation To Change The Tint For RecordingEN33 To Control The Speaker VolumeAvailable only with the remote control provided  pg Playback Zoom and Playback Special EffectsUsing Menus For Detailed Adjustment EN35 Playback SoundDisplay 36 EN Set the VIDEO/DSC Switch toPower Switch to Normal PlaybackEN37 Index ScreenIndex Playback To stop the Slide Show, press 38 ENSlide Show After , press 4/6. To stop the Slide Show, pressTo Protect AN Image Protecting ImagesEN39 To Remove Protection40 EN To Delete ALL ImagesYou can initialize the camcorder’s built-in memory anytime Initializing The Built-in MemoryEN41 42 EN VCRTo monitor the picture and sound from If using a VCR . . . go to step If not . . . go to stepEN43 Date/time information cannot be captured into the PC 44 ENConnection To a Personal Computer Make sure all units are turned off Connection To a Video Unit Equipped With a DV ConnectorEN45 Core filter reduces interference 46 ENDubbing To a VCR YTU94146A S-Video cableTo use this camcorder as a player Make sure the camcorder’s power is offEN47 Memory To a Tape Indicator disappears when dubbing is complete48 EN Dubbing Images Recorded On a Tape To The Built-in Memory EN4950 EN Installing The BatteriesRe-attach the battery compartment cover EN51 FF ButtonFeature Playback Zoom Feature Slow-Motion PlaybackFeature Frame-By-Frame Playback 52 ENFeature Playback Special Effects EN53SET REMOTE/VCR Code 54 ENRandom Assemble Editing R.A.Edit You are now ready to try Random Assemble EditingMake Connections JVC VCR equipped with a remote pause connectorEN55 VCR other than above56 EN Select ScenesEN57 Automatic Editing to VCRDiagnosing VCR/CAMCORDER Timing 58 ENFor More Accurate Editing Recording deckAdjustment of VCR/CAMCORDER Timing EN59To hear the dubbed sound during playback 60 ENAudio Dubbing Sound is not heard from the speaker during Audio DubbingInsert Editing EN6162 EN Focus does not adjust automaticallyClean the lens and check Corrective ActionEffects you want before EN63Digital Zoom does not work For editing was registered Starting editing  pgTroubleshooting 64 ENEN65 Images stored in the built- in memory cannot be deletedAngle of the LCD monitor When the LCD monitors66 EN WhitishOr channel appropriate EN67An unusual mark appears 68 EN Function Mode  pgDuring Video Recording Only 70 EN Auto PhotoEN71 LCD Monitor/Viewfinder Indications During Video PlaybackLCD Monitor/Viewfinder Indications During D.S.C. Playback Switch is set to or and the VIDEO/DSC Switch is set to Displays the battery remaining powerAppears when no tape is loaded  pg VIDEO/DSC Switch is set to VideoVIDEO/DSC Switch is set to Appears when the date/time is not set  pgFor replacement Audio  pg74 EN 345 6 7 # $ %EN75 After Use Cleaning The Camcorder76 EN EN77 To prevent damage and prolong service lifeTemperature Range Specifications To avoid hazards . . .Terminals78 EN EN79 Date/Time Display  pg , 34 80 EN pg , 9 Icons  pgEN81 For Digital Video Camera 82 ENFor General For Digital Still CameraFor Connectors EN83GR-DVL505