JVC GR-DVL505, GR-DVL805 specifications 78 EN

Page 78

78 EN

.... do not load and unload the cassette

repeatedly without allowing the tape to run at all. This slackens the tape and can result in damage.

.... do not open the front tape cover. This exposes

the tape to fingerprints and dust.

2. Store cassettes . . .

.... away from heaters or other heat sources.

.... out of direct sunlight.

.... where they won’t be subject to unnecessary

shock or vibration.

.... where they won’t be exposed to strong

magnetic fields (such as those generated by motors, transformers or magnets).

.... vertically, in their original cases.

LCD Monitor

1.To prevent damage to the LCD monitor, DO NOT . . .

.... push it strongly or apply any shocks.

.... place the camcorder with the LCD monitor on the bottom.

2.To prolong service life . . .

.... avoid rubbing it with coarse cloth.

3.Be aware of the following phenomena for LCD monitor use.

These are not malfunctions:

While using the camcorder, the surface around the LCD monitor and/or the back of the LCD monitor may heat up.

If you leave power on for a long time, the surface around the LCD monitor becomes hot.

Main Unit

1. For safety, DO NOT . . .

.... open the camcorder’s chassis.

.... disassemble or modify the unit.

.... short-circuit the terminals of the battery pack.

Keep it away from metallic objects when not in use.

.... allow inflammables, water or metallic objects

to enter the unit.

.... remove the battery pack or disconnect the

power supply while the power is on.

.... leave the battery pack attached when the

camcorder is not in use.

2. Avoid using the unit . . .

.... in places subject to excessive humidity or dust.

.... in places subject to soot or steam such as near

a cooking stove.

.... in places subject to excessive shock or

vibration.

.... near a television set.

CAUTIONS (cont.)

.... near appliances generating strong magnetic or

electric fields (speakers, broadcasting anten- nas, etc.).

.... in places subject to extremely high (over 40°C

or 104°F) or extremely low (under 0°C or 32°F) temperatures.

3. DO NOT leave the unit . . .

.... in places of over 50°C (122°F).

.... in places where humidity is extremely low

(below 35%) or extremely high (above 80%).

.... in direct sunlight.

.... in a closed car in summer.

.... near a heater.

4.To protect the unit, DO NOT . . .

.... allow it to become wet.

.... drop the unit or strike it against hard objects.

.... subject it to shock or excessive vibration during transportation.

.... keep the lens directed at extremely bright objects for long periods.

.... expose the lens to direct sunlight.

.... carry it by holding the LCD monitor or the viewfinder.

.... swing it excessively when using the shoulder strap or the grip.

5.Dirty heads can cause the following problems:

No picture during playback.

Blocks of noise appear during playback.

During recording, the Head Clog Warning indicator “” appears.

In such cases, use an optional cleaning cassette. Insert it and play back. If the cassette is used more than once consecutively, damage to the video heads may result. After the camcorder plays back for about 20 seconds, it stops automatically. Also refer to the cleaning cassette’s instructions.

If, after using the cleaning cassette, the problems still exist, consult your nearest JVC dealer. Mechanical moving parts used to move the video heads and video tape tend to become dirty and worn out over time. In order to maintain a clear picture at all times, periodic check-ups are recommended after using the unit for about 1,000 hours. For periodic check-ups please consult your nearest JVC dealer.

Image 78
Contents GR-DVL805 GR-DVL505 Dear Customer It is recommended that youPower Lines Power SourcesPower Cord Protection Grounding or PolarizationDamage Requiring Service AccessoriesCleaning Replacement PartsSafety Precautions Make sure you only use cassettes with the Mini DV markFor remote control unit AC Power Adapter/Charger Remote Control UnitAA-V40U RM-V716U AAA R03 Battery x Shoulder Strap Editing CableAutomatic Demonstration Lithium-ion is vulnerable in colder temperatures PowerCharging the Battery Pack About BatteriesTo Detach The Battery Pack Using the Battery PackUsing AC Power Approximate recording time10 EN Grip AdjustmentViewfinder Adjustment Shoulder Strap AttachmentDate/Time Settings EN1112 EN Loading/Unloading a CassetteEN13 Recording Mode SettingSet the tape recording mode depending on your preference During playback of a tape recorded on anotherPicture Quality Mode Setting 14 ENVIDEO/DSC Switch Position Operation ModePower Switch Position Manual EN1516 EN Power  pgTo Adjust The Brightness Of The Display Load a Cassette  pgSELF-RECORDING EN17Journalistic Shooting During recording, sound is not heard from the speaker18 EN Power Switch Snapshot For Video RecordingSnapshot Mode Selection Snapshot RecordingImage is stored in the camcorder’s built-in memory Basic Shooting SnapshotAvailable Snapshot modes are the same as those on pg To Delete Unwanted Still ImagesZoom Slide the Power Zoom Lever towards T20 EN Zoom OutWhen a blank portion is recorded on a tape EN21Proper recording 22 EN Feature Video LightTo brighten the scene when natural lighting is too dim Set Light OFF/AUTO/ON as requiredEN23 Feature Auto FocusFeature Manual Focus To obtain correct focusSee pg Go to stepMenu Screen Explanations EN25When shooting subjects with vertical or horizontal stripes Side LED indicator  p , 75 lights on the camcorder whenPower Switch is set to or When shooting dark or dim subjectsEN27 To Deactivate The Selected Effect Fade/Wipe EffectsPicture Wipe or Dissolve Selection Sound at the end of the last recorded scene is not storedEN29 Fader And Wipe MenuMenu Slow Slow Shutter To Deactivate The Selected ModeProgram AE With Special Effects SlowExposure Control Iris LockEN31 To Return To Automatic White Balance White Balance AdjustmentManual White Balance Operation To Change The Tint For RecordingEN33 To Control The Speaker VolumeAvailable only with the remote control provided  pg Playback Zoom and Playback Special EffectsUsing Menus For Detailed Adjustment Playback Sound DisplayEN35 36 EN Set the VIDEO/DSC Switch toPower Switch to Normal PlaybackIndex Screen Index PlaybackEN37 To stop the Slide Show, press 38 ENSlide Show After , press 4/6. To stop the Slide Show, pressTo Protect AN Image Protecting ImagesEN39 To Remove Protection40 EN To Delete ALL ImagesInitializing The Built-in Memory EN41You can initialize the camcorder’s built-in memory anytime 42 EN VCRIf using a VCR . . . go to step If not . . . go to step EN43To monitor the picture and sound from 44 EN Connection To a Personal ComputerDate/time information cannot be captured into the PC Connection To a Video Unit Equipped With a DV Connector EN45Make sure all units are turned off Core filter reduces interference 46 ENDubbing To a VCR YTU94146A S-Video cableMake sure the camcorder’s power is off EN47To use this camcorder as a player Indicator disappears when dubbing is complete 48 ENMemory To a Tape Dubbing Images Recorded On a Tape To The Built-in Memory EN49Installing The Batteries Re-attach the battery compartment cover50 EN EN51 FF ButtonFeature Playback Zoom Feature Slow-Motion PlaybackFeature Frame-By-Frame Playback 52 ENFeature Playback Special Effects EN53SET REMOTE/VCR Code 54 ENRandom Assemble Editing R.A.Edit You are now ready to try Random Assemble EditingMake Connections JVC VCR equipped with a remote pause connectorEN55 VCR other than above56 EN Select ScenesEN57 Automatic Editing to VCRDiagnosing VCR/CAMCORDER Timing 58 ENFor More Accurate Editing Recording deckAdjustment of VCR/CAMCORDER Timing EN59To hear the dubbed sound during playback 60 ENAudio Dubbing Sound is not heard from the speaker during Audio DubbingInsert Editing EN6162 EN Focus does not adjust automaticallyClean the lens and check Corrective ActionEffects you want before EN63Digital Zoom does not work For editing was registered Starting editing  pgTroubleshooting 64 ENEN65 Images stored in the built- in memory cannot be deletedAngle of the LCD monitor When the LCD monitors66 EN WhitishEN67 An unusual mark appearsOr channel appropriate 68 EN Mode  pg During Video Recording OnlyFunction 70 EN Auto PhotoLCD Monitor/Viewfinder Indications During Video Playback LCD Monitor/Viewfinder Indications During D.S.C. PlaybackEN71 Switch is set to or and the VIDEO/DSC Switch is set to Displays the battery remaining powerAppears when no tape is loaded  pg VIDEO/DSC Switch is set to VideoVIDEO/DSC Switch is set to Appears when the date/time is not set  pgFor replacement Audio  pg74 EN 345 6 7 # $ %EN75 Cleaning The Camcorder 76 ENAfter Use EN77 To prevent damage and prolong service lifeTemperature Range Specifications To avoid hazards . . .Terminals78 EN EN79 Date/Time Display  pg , 34 80 EN pg , 9 Icons  pgEN81 For Digital Video Camera 82 ENFor General For Digital Still CameraFor Connectors EN83GR-DVL505