JVC GR-DVL805, GR-DVL505 Appears when the date/time is not set
pg, For replacement, Audio
pg

		EN73
Indications	Function
	●Appears when the date/time is not set.	( pg. 11)
SET DATE/TIME!	●Appears when the built-in clock battery runs out and the
	previously set date/time is erased. Consult your nearest JVC dealer
	for replacement.
LENS CAP	Appears for 5 seconds after power is turned on if the lens cap is attached.
A. DUB ERROR!	●Appears if Audio Dubbing is attempted on a blank portion of a tape.
		( pg. 60)
A. DUB ERROR!	●Appears if Audio Dubbing is attempted on a tape recorded in the LP
<CANNOT DUB	mode.	( pg. 60)
ON AN LP RECORDED	●Appears if Audio Dubbing is attempted on a tape recorded in 16-bit
TAPE>
	audio.	( pg. 60)
<CANNOT DUB
	●Appears if A. DUB (e) on the remote control is pressed when the erase
ON A 16BIT
	protection tab is set to “SAVE”.	( pg. 60)
RECORDING>
<CHECK TAPE’S ERASE
PROTECTION SWITCH>
INSERT ERROR!	●Appears if Insert Editing is attempted on a blank portion of a tape.
		( pg. 61)
INSERT ERROR!	●Appears if Insert Editing is attempted on a tape recorded in the LP mode.
<CANNOT EDIT		( pg. 61)
ON AN LP RECORDED	●Appears if INSERT (w) on the remote control is pressed when the erase
TAPE>	protection tab is set to “SAVE”.	( pg. 61)
<CHECK TAPE’S ERASE
PROTECTION SWITCH>
MEMORY IS FULL	Appears when the built-in memory is full and shooting is not possible.

●Appears if dubbing of copyguarded signals is attempted while this camcorder is being used as a recorder.

●Appears if the built-in memory is full when dubbing still images recorded

on the tape to the built-in memory. (
pg. 49)

	●Appears in the following cases when dubbing still images stored in the
COPYING FAILED	built-in memory to a tape:

–when condensation occurs.

–when no tape is loaded.

–when the erase protection tab is set to “SAVE”.

–when a tape in another format is loaded.

	– when the tape ends.	( pg. 48)
NO IMAGES STORED	Appears if there are no images stored in the built-in memory when the
	Power Switch is set to “	” and the VIDEO/DSC Switch is set to “ ”.
E01 — E06	The error indications (E01 — E06) show what type of malfunction has
	occured. When an error indication appears, the camcorder turns off
UNIT IN SAFEGUARD
	automatically. Remove the power supply (battery, etc.) and wait a few
MODE REMOVE AND
	minutes for the indication to clear. When it does, you can resume using the
REATTACH BATTERY
	camcorder. If the indication remains, consult your nearest JVC dealer.