JVC GR-SXM260 manual Connections To a TV/VCR, Tape Dubbing

Connections To A TV/VCR

1)Make sure all units are turned off.

2)Connect the camcorder to a TV or VCR using optional video and audio cables. If using both TV and VCR, connect the VCR output to the TV input.

3)Turn on all units. Set the VCR to its AUX input mode, and set the TV to its VIDEO mode.

•Use the AC Adapter as the power supply.

•Be sure to adjust the TV sound volume to its minimum level to avoid a sudden burst of sound when the camcorder is turned on.

•If you have a TV or speakers that are not specially shielded, do not place the speakers adjacent to the TV as interference will occur in the camcorder playback picture.

•The S-Video cable connection can improve the dubbed picture quality. The S-Video cable is optional. Be sure to use the following cable: YTU94146A S-Video cable.

Consult the JVC Service Center described on the sheet included in the package for details on its availability. Make sure to connect the end with a core filter to the camcorder. The core filter reduces interference.

Tape Dubbing

1)Connect the camcorder and the VCR

(
“Connections To A TV/VCR”). Set the Power Switch @ to “PLAY” while pressing down the Lock Button ! located on the switch, turn on the VCR’s power, and insert the appropriate cassettes in the camcorder and the VCR. Engage the VCR’s AUX and Record-Pause modes.

2)Press 4/6& to find a spot just before the edit- in point. Once it is reached, press 4/6& again.

3)Press 4/6& and engage the VCR’s Record mode.

4)Engage the VCR’s Record-Pause mode and press 4/6&.

•Repeat steps 2) through 4) for additional editing, then stop the VCR and camcorder when finished.

To S-Video Output 5

Connector cover

White to

Audio

Output 6

Yellow to

Video

Output 7

S-Video cable (optional)

To S-Video Input

TV

VCR

A/V cable

(optional)

White to

Audio Input

Yellow to Video Input

15