21” ‘EASY LINE’ WALK BEHIND MOWERS
Safety Instructions & Operators Manual for
MODELS
S211 SP211 SPV211 SPV211S SPV211E
PROTECTION FOR CHILDREN
IMPORTANT SAFETY INSTRUCTIONS
SLOPE OPERATION
PREPARATION
MAINTENANCE AND STORAGE
IMPORTANT SAFETY INSTRUCTIONS
SAFE HANDLING OF GASOLINE
OPERATION
MAINTENANCE AND STORAGE
IMPORTANT SAFETY INSTRUCTIONS
The gross power rating labels for individual gas engine models meet or exceed SAE Society of Automotive Engineers code J1940 Small Engine Power & Torque Rating Procedure and rating performance has been obtained and corrected in accordance with SAE J1995 Revision 2002-05. Actual gross engine power may be lower and is affected by, but not limited to, ambient operating conditions and engine to engine variability. Given both the wide array of products on which engines are placed, and the variety of environmental issues applicable to operating the equipment, the gas engine will not develop the rated gross power when used in a given piece of power equipment actual “on-site” or net horsepower. This difference is due to a variety of factors including, but not limited to, accessories air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc., application limitations, ambient operating conditions temperature, humidity, altitude, and engine to engine variability
TABLE OF CONTENTS
MODEL SPV211 SHOWN
Section 1 - FAMILIARIZATION
1.1 INTRODUCTION
1.2 NOMENCLATURE
2.1 PRE-START CHECK LIST
Section 2 - OPERATING INSTRUCTIONS
2.2 STARTING & OPERATION 2.2.1. ENGINE & BLADE
Section 2 - OPERATING INSTRUCTIONS
2.5 HANDLE HEIGHT ADJUSTMENT
2.2 STARTING & OPERATION 2.2.2. PROPELLING MOWER
Self Propelled Models Only
Set all wheels in the highest cutting position Notch
Section 2 - OPERATING INSTRUCTIONS
Section 2 - OPERATING INSTRUCTIONS
INSTALL LOCK
Section 3 - MAINTENANCE
3. Replace rear cover
Section 3 - MAINTENANCE
END VIEW OF BLADE ASSEMBLY
Section 4 - REPAIR & ADJUSTMENTS
NEW BLADE WEAR LIMIT NOTCH STARTS DANGEROUS CONDITION
DO NOT USE ON MOWER REPLACE WITH NEW BLADE
4.2 WHEEL DRIVE CONTROL ADJUSTMENT
Section 4 - REPAIR & ADJUSTMENTS
IMPORTANT INCORRECT ADJUSTMENT CAN CAUSE DAMAGE TO THE TRANSMISSION
FIGURE 4.5a
ADJUSTMENT HOLES INCREASE MINIMUM GROUND SPEED DECREASE MINIMUM
Section 4 - REPAIR & ADJUSTMENTS
GROUND SPEED LEVER IN ‘SLOW’ POSITION SPRING HAS NO TENSION INNER NUT
OUTER NUT BELT IS RELAXED
2. Remove blade. Refer to Section “Blade Sharpening”
Section 4 - REPAIR & ADJUSTMENTS
Battery Condition
Section 4 - REPAIR & ADJUSTMENTS
THREADED FASTENERS REAR COVER
Section 4 - REPAIR & ADJUSTMENTS
PROBLEM
TROUBLESHOOTING
PROBABLE CAUSE
CORRECTIVE ACTION
MAINTENANCE/REPLACEMENT PARTS
SERVICEection3 SCHEDULE- OP RATING INSTRUCTIONS
2 YEAR LIMITED WARRANTY
PRIMARY MAINTENANCE
PRIMARY MAINTENANCE
PRIMARY MAINTENANCE
PRIMARY MAINTENANCE
Call the Snapper Customer Relations Center at
SNAPPER PRODUCT REGISTRATION FORM
Page
Snapper products are built using engines that meet or exceed all applicable emissions requirements on the date manufactured. The labels on those engines contain very important emissions information and critical safety warnings. Read, Understand, and Follow all warnings and instructions in this manual, the engine manual, and on the machine, engine and attachments. If you have any questions about your Snapper product, contact your local authorized Snapper dealer or contact Snapper Customer Service at Snapper, McDonough, GA. 30253. Phone
Safety Instructions & Operators Manual for
21” ‘EASY LINE’ WALK BEHIND MOWERS
MANUAL No. 7101295 I.R. 1/3/2007 TP 100-5252-IR-WB-N