Contents
S211 SP211 SPV211 SPV211S SPV211E
Safety Instructions & Operators Manual for
21” ‘EASY LINE’ WALK BEHIND MOWERS
MODELS
PREPARATION
IMPORTANT SAFETY INSTRUCTIONS
PROTECTION FOR CHILDREN
SLOPE OPERATION
OPERATION
IMPORTANT SAFETY INSTRUCTIONS
MAINTENANCE AND STORAGE
SAFE HANDLING OF GASOLINE
IMPORTANT SAFETY INSTRUCTIONS
MAINTENANCE AND STORAGE
The gross power rating labels for individual gas engine models meet or exceed SAE Society of Automotive Engineers code J1940 Small Engine Power & Torque Rating Procedure and rating performance has been obtained and corrected in accordance with SAE J1995 Revision 2002-05. Actual gross engine power may be lower and is affected by, but not limited to, ambient operating conditions and engine to engine variability. Given both the wide array of products on which engines are placed, and the variety of environmental issues applicable to operating the equipment, the gas engine will not develop the rated gross power when used in a given piece of power equipment actual “on-site” or net horsepower. This difference is due to a variety of factors including, but not limited to, accessories air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc., application limitations, ambient operating conditions temperature, humidity, altitude, and engine to engine variability
TABLE OF CONTENTS
1.2 NOMENCLATURE
Section 1 - FAMILIARIZATION
MODEL SPV211 SHOWN
1.1 INTRODUCTION
Section 2 - OPERATING INSTRUCTIONS
2.1 PRE-START CHECK LIST
2.2 STARTING & OPERATION 2.2.1. ENGINE & BLADE
Self Propelled Models Only
2.5 HANDLE HEIGHT ADJUSTMENT
Section 2 - OPERATING INSTRUCTIONS
2.2 STARTING & OPERATION 2.2.2. PROPELLING MOWER
Set all wheels in the highest cutting position Notch
Section 2 - OPERATING INSTRUCTIONS
Section 2 - OPERATING INSTRUCTIONS
INSTALL LOCK
Section 3 - MAINTENANCE
3. Replace rear cover
Section 3 - MAINTENANCE
DO NOT USE ON MOWER REPLACE WITH NEW BLADE
Section 4 - REPAIR & ADJUSTMENTS
END VIEW OF BLADE ASSEMBLY
NEW BLADE WEAR LIMIT NOTCH STARTS DANGEROUS CONDITION
FIGURE 4.5a
Section 4 - REPAIR & ADJUSTMENTS
4.2 WHEEL DRIVE CONTROL ADJUSTMENT
IMPORTANT INCORRECT ADJUSTMENT CAN CAUSE DAMAGE TO THE TRANSMISSION
OUTER NUT BELT IS RELAXED
Section 4 - REPAIR & ADJUSTMENTS
ADJUSTMENT HOLES INCREASE MINIMUM GROUND SPEED DECREASE MINIMUM
GROUND SPEED LEVER IN ‘SLOW’ POSITION SPRING HAS NO TENSION INNER NUT
2. Remove blade. Refer to Section “Blade Sharpening”
Section 4 - REPAIR & ADJUSTMENTS
Battery Condition
Section 4 - REPAIR & ADJUSTMENTS
THREADED FASTENERS REAR COVER
Section 4 - REPAIR & ADJUSTMENTS
CORRECTIVE ACTION
TROUBLESHOOTING
PROBLEM
PROBABLE CAUSE
MAINTENANCE/REPLACEMENT PARTS
SERVICEection3 SCHEDULE- OP RATING INSTRUCTIONS
2 YEAR LIMITED WARRANTY
PRIMARY MAINTENANCE
PRIMARY MAINTENANCE
PRIMARY MAINTENANCE
PRIMARY MAINTENANCE
Call the Snapper Customer Relations Center at
SNAPPER PRODUCT REGISTRATION FORM
Page
MANUAL No. 7101295 I.R. 1/3/2007 TP 100-5252-IR-WB-N
Safety Instructions & Operators Manual for
Snapper products are built using engines that meet or exceed all applicable emissions requirements on the date manufactured. The labels on those engines contain very important emissions information and critical safety warnings. Read, Understand, and Follow all warnings and instructions in this manual, the engine manual, and on the machine, engine and attachments. If you have any questions about your Snapper product, contact your local authorized Snapper dealer or contact Snapper Customer Service at Snapper, McDonough, GA. 30253. Phone
21” ‘EASY LINE’ WALK BEHIND MOWERS