JVC GR-SXM47 Basic Connections, Tape Dubbing, EN33, Power supply instead of the battery pack pg

Press 4/6on the camcorder and engage the VCR’s Record mode.

Engage the VCR’s Record-Pause mode and press 4/6on the camcorder.

Connect the VCR output to the TV input, referring to your VCR’s instruction manual.

Engage the VCR’s AUX and Record-Pause modes.

Basic Connections

1 Make sure all units are turned off.

2 Connect the camcorder to a TV or VCR as shown in the illustration (☞ pg. 32).

If using a VCR . . . go to step 3.

If not . . . go to step 4.

3

4 Turn on the camcorder, the VCR and the TV.

5 Set the VCR to its AUX input mode, and set the TV to its VIDEO mode.

NOTES:

●It is recommended to use the AC Adapter as the

power supply instead of the battery pack (☞ pg. 7).

●If your VCR has an S-Video input connector, connect the camcorder and the VCR using the provided S-Video cable. This can improve the dubbed picture quality (GR-SXM47/SX22 only).

●To monitor the picture and sound from the camcorder without inserting a tape, set the camcorder’s Power Switch to “” or “ ”, then set your TV to the appropriate input mode.

●Make sure you adjust the TV sound volume to its minimum level to avoid a sudden burst of sound when the camcorder is turned on.

●If you have a TV or speakers that are not specially shielded, do not place the speakers adjacent to the TV as interference will occur in the camcorder playback picture.

EN33

Tape Dubbing

1 Following the illustration on pg. 32, connect the camcorder and the VCR.

2 Set the camcorder’s Power Switch to “ ”, turn on the VCR’s power, and insert the appropriate cassettes in the camcorder and the VCR.

3

4 Engage the camcorder’s Play mode to find a spot just before the edit-in point. Once it is reached, press 4/6on the camcorder.

5

6

7 Repeat steps 4 through 6 for additional editing, then stop the VCR and camcorder when finished.