JVC GR-SXM47 specifications As necessary before you start shooting, Equipped with LCD monitor only

DETAILS			EN	35
I T E M S		N O T E S
➪ Power	❍ Perform charging where the temperature is between 10°C and 35°C. 20°C
(☞ pg. 6)	to 25°C is the ideal temperature range for charging. If the environment is
	too cold, charging may be incomplete.
	❍ Charging times are for a fully discharged battery pack.
	❍ Charging time varies according to the ambient temperature and the status of
	the battery pack.
	❍ To avoid interference with reception, do not use the AC Adapter near a
	radio.
	❍ Since the AC Adapter processes electricity internally, it becomes warm
	during use. Be sure to use it only in well-ventilated areas.
	❍ The following operation stops charging or discharging:
	•Set the Power Switch to “	”, “ ” or “ ”.
	•Disconnect the AC Adapter from the camcorder.
	•Unplug the AC Adapter’s power cord from the AC outlet.
	•Detach the battery from the camcorder.

➪ Date/Time	❍ The date/time cannot be stored in memory if the built-in clock battery runs
Settings	out. Consult an authorised JVC dealer for replacement, or set the date/time
(☞ pg. 9)	as necessary before you start shooting.
➪ Recording	❍ When the Power Switch is set to “ ” or “ ” and the LCD monitor is
(☞ pg. 14, 15)	opened at an angle of 60 degrees or more, the LCD monitor switches on
	and the viewfinder switches off automatically to save power (models
	equipped with LCD monitor only).

❍The cassette holder cannot be opened unless a power supply is attached.

❍There may be a delay after you slide EJECT until the cassette holder opens. Do not use force.

❍The time required to calculate the remaining tape length, and the accuracy of the calculation, may vary according to the type of tape used.

❍The tape remaining time indicator is correct only if the correct tape length has been selected (☞ pg. 12).

❍“TAPE END” appears when the tape reaches its end, and the power goes off automatically if left in this condition for 5 minutes.

“TAPE END” also appears when a cassette whose tape is already at its end is loaded.

❍If the Recording Start/Stop button is pressed after the Record-Standby mode has continued for over 5 minutes, recording may not start immediately.

❍While shooting, sound is not heard from the speaker (models equipped with LCD monitor only).

➪ TBC	❍ The “TBC” indicator turns green (grey with a camcorder equipped with a
(Time Base
	black/white viewfinder) while TBC is working.
Corrector)	❍ TBC does not work during still playback and shuttle search.
(☞ pg. 31)
	❍ The “TBC” indicator turns white while TBC is not operative.
	❍ It may take a few seconds before TBC actually starts working.
	❍ The picture may be distorted if the TBC mode is activated or deactivated at
	the edit-in/-out points or when normal playback resumes after still playback
	or shuttle search.
	❍ If the playback picture is distorted when TBC is set to on, turn off TBC.