JVC GY- HD111 HD CAMERA RECORDER manual Battery Operation Cont’d

Page 30

PREPARATIONS

Battery Operation (Cont’d)

„Remaining Battery Power Display

LCD monitor/Viewfinder

„Operating Time with Battery Pack

When a fully charged battery pack is attached, the approxi- mate continuous operating time is as follows

Battery Pack

Continuous Operating Time (at 25°C (77°F))

BN-V428

Approx. 40 minutes

BN-V438

Approx. 60 minutes

 

 

When the remaining battery power is nearly exhausted, the following warnings will be generated.

„Viewfinder screen or LCD monitor

When a Status screen is displayed (excluding the STATUS 2, 3 screen in the Camera mode)

• Alarm indication: LOW VOLTAGE displayed.

„FRONT and BACK TALLY lamp on camera: Blinks

„Monitoring loudspeaker and PHONES jack: Alarm sound

MEMO

After the remaining battery power warnings appear, the GY- HD110 automatically stops operation if the battery power operation is continued.

„Battery Recharge Times

Battery pack

Recharging time of

Successive recharging

a single pack

time of two packs

 

 

 

 

BN-V428

Approx. 3 hr. 20 min

Approx. 6 hr. 40 min

 

 

 

BN-V438

Approx. 4 hr. 20 min

Approx. 8 hr. 40 min

 

 

 

When charged at temperatures between 20°C (68°F) and 25°C (77°F).

When charging battery packs after a long storage period, charging time will be longer than indicated above.

When two battery packs are attached, they will be recharged in the order that they are attached.

Battery operating time may differ depending on the age of the battery pack, charging conditions and the operating environment, etc. Use the values in the table on the above for approximate reference times.

Operating time is reduced in areas with a cold environ- ment.

Operating time is reduced when the power zoom lens and LCD are used frequently.

„Precautions for the Battery Pack

When the battery pack is not in use, it must be stored in a cool, dry place.

Do not leave the battery pack in a place where it might be subject to a high temperature (under direct sunlight in a car, etc.), this could cause leakage of the fluid or shorten service life.

When the terminal section of the battery pack gets dirty, the operating time will be shortened.

If the operating time becomes greatly reduced even imme- diately after recharging, the service life of the battery pack is nearly finished.

Purchase a new battery pack.

„Recharging

Recharge the battery pack after completely discharging it. Repeated recharging with residual charge remaining could result in reduced battery capacity.

If the battery capacity is reduced by repeating incomplete recharging, or recharging without discharging, once dis- charge the battery pack completely, then recharge it to restore the battery capacity.

If the battery pack is recharged with its internal temperature raised immediately after use, recharging may not be per- formed completely.

Perform charging in an environment where the tempera- ture is between 10°C (50°F) and 35°C (95°F). 20°C (68°F) to 25°C (77°F) is the ideal temperature range for charging. If the environment is too cold, charging may not complete.

34

Image 30
Contents GY-HD111 For Customer UseAccessories Excluding the CHU/CHE Model LensMicrophoneMain Features Contents Contents CONTROLS, Indicators and Connectors Zoom LensTh16 x 5.5BRMU Front Section Rear Section 5CAM/VTR Camera/VTR mode switch button 2CH-1/CH-2 Audio Select CH-1/CH-2 audio selector switch3TC Display TC/UB display switch LCD DoorRight Side Section DStand BGAIN Sensitivity selector switchCWHT.BAL White balance switch HHDV/DV LEDLeft Side Section Top Section FDISPLAY Display button GVTR VTR indicatorTop Section Cont’d KPLAY/STILL Play/still buttonIndications on the LCD Monitor and in the Viewfinder „ Status Screens„ Status Screens in the Camera Mode Setting Status Contents of IndicationsIndications on the LCD Monitor and in the Viewfinder Cont’d Contents See CH-1O O O O O O O O O \ \ \ CH-2O O O O O O O O O \ \ \ND1 Filter ND1 1/4ND Indication Indication Contents „ Status Screen in VTR Mode „ Magnified Status Indications on the LCD Monitor NDF„ Alarm Message Display „ Auto White Balance Indication Camera Mode only„ Menu Setting Screen „ Safety Zone Indication Camera mode onlyVF Display Preparations Basic SystemAttaching the Microphone Provided How to Attach the ViewfinderAttaching the Zoom Lens Knob„ Inserting an SD Memory Card Inserting an SD Memory CardAbout the Viewfinder Cable „ Taking out the SD memory card„ Charging the Built-in Battery „ How to chargeAC Operation „ Attaching the Battery Pack on the GY HD110 Battery Operation„ Charging the Battery Pack „ Detaching the Battery Pack from the GY HD110Battery Operation Cont’d „ Turning the Power OFF Turning the Power on„ Turning the Power on Preparations for Operation„ Unloading the Cassette Loading/Unloading the Cassette„ Cassette Loading ModeSetting and Displaying the Date and Time „ Setting the Date and Time StyleSetting and Displaying the Date and Time Cont’d „ Setting the Date and Time„ Displaying the Time and Date on the Screen „ Setting Displaying Time CodeDrop Presetting and Recording of Time CodeDrop frame/Non-drop frame mode NON„ Presetting time cord data „ Presetting user’s bit data„ Zero-resetting the Time Code or User’s Bit Data „ Settings and Operations „ ConnectionsSlave unit GY-HD110U/GY-HD111E Screen Adjustment Viewfinder AdjustmentBack Focus Adjustment „ Adjustment procedure White Balance Adjustment„ White Balance Adjustment „ Error messages„ Setting the REC Item Setting the Video Format„ Setting the Frame Rate Item „ About the Motion Smooth FunctionCamera Settings Screen Size 43/169 Mode SelectionND Filter „ Adjusting Audio during Recording Audio Input Signal Selection„ Selecting the audio signal input „ Selecting the CH-2 channel input con Nector„ Monitoring Audio during Recording LOW/MIDDLE/HIGHShooting Operation Basic Recording Operation„ About the Focus Assist Function „ If the Record-Standby Mode Continues Shooting OperationFunction/Initial Setting Header REC Function„ How to set the Header REC menu screen Fast-Forward, Rewind Playback ModePlayback Procedure SearchStereo Outputting AudioMIX Monitor PB Audio CH DV„ Connecting the IEEE1394 Cable Using External ComponentsConnecting the Video Signal Cables „ Displaying AlarmsDubbing with AV Devices HDV/DV Dubbing OFF Backup Recording „ Settings„ Operation Menu Screen Configuration Menu ScreensSetting Menu Screens TOP Menu Screen Function/Setting bold characters indicate initial settings Setting DescriptionVideo Format Menu Screen Native Connector G Unconnected Connected Output SignalInitial settings U model 7.5% E model 0.0% AutoCamera Operation Menu Screen 3200KOFF High Camera Process 1/2 Menu ScreenMiddle NormalCamera Process 2/2 Menu Screen 108%Advanced Process Menu Screen StandardColor Matrix Adjust Menu Screen Skin Color Adjust Menu ScreenStop Step Switch Mode Menu ScreenREC Item Setting for Step Setting for Variable None50dB AUDIO/MIC 1/2 Menu Screen20dB 48KAUDIO/MIC 2/2 Menu Screen MIXCH1/2 LCD/VF 1/3 Menu Screen 70-80%Blue LCD/VF 2/3 Menu Screen VoltageLCD/VF 3/3 Menu Screen ColorTC/UB/CLOCK Menu Screen ExecuteDrop Disable Header REC Menu ScreenDATE+TIME TIME/DATE Menu ScreenBARS+CAM Variation Range U model MM/DD/YY E model DD/MM/YYOthers 1/2 Menu Screen 3MINBlink Others 2/2 Menu Screen 1394DR-HD100 A.OFF Menu ALL ResetOthers 2/2 Menu Screen Cont’d Drum Hour„ Loading a menu settings file File Manage Menu Screen„ Displaying the File Manage menu Screen „ Saving settings „ Error displaysFile Manage Menu Screen Cont’d „ Resetting the menu settings to the fac Tory settings „ Initializing formatting an SD memory CardFeatures of the Camera Section How to Use Skin Detail„ Setting the skin detail function color and range Features of the Camera Section „ Using the Skin Detail FunctionOutputting color bars Others Display Status ActionError Code Error Details GY-HD110 Operation Remedy Blinking Pattern Remaining Battery/Tape Viewfinder ScreenTroubleshooting Symptoms RemedyEuropean Union How to Display the Hour MeterInformation for Users on Disposal of Old Equipment Business users Other Countries outside the European UnionSpecifications Accessories