JVC LYT0191-001B Angle of the LCD monitor, Whitish, LCD monitor. When This happens, the displayed

EN73

SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION

26.During recording, sound 26. •The optional headphones are

cannot be heard.	not connected to the head-
	phones connector.
	•The sound volume of the
	headphones connector was
	not adjusted appropriately. The
	sound volume at this point is
	the same as the level it was
	adjusted to during playback.

26.•Connect the optional headphones to the head- phones connector

(☞ pg. 76).

•Adjust the sound volume during playback

(☞ pg. 49).

27. During recording, the	27. •“DISPLAY” is set to “OFF” in	27. •Set “DISPLAY” to “ON” in
date/time does not appear.	the Date/Time Menu.	the Date/Time Menu
	•Interface shooting is	(☞ pg. 11).
	performed.	•During interface shooting,
		the date/time does not
		appear (☞ pg. 23).
		•Press the IND.ON/OFF
		button for longer than 1
		second to make the
		indicators appear
		(☞ pg. 22).
28. The indicators and	28. •“ON SCREEN” is set to	28. •Set “ON SCREEN” to “ON”
messages do not appear	“OFF” in the Date/Time	in the Date/Time Menu
on screen.	Menu.	(☞ pg. 25).
		•Press the IND.ON/OFF
		button for longer than 1
		second to make the
		indicators appear
		(☞ pg. 22).
29. The indicators do not	29. •You have made the indica-	29. •Press the IND.ON/OFF button
appear on the LCD	tors disappear.	for longer than 1 second to
monitor or in the		make the indicators appear
viewfinder.		(☞ pg. 22).
30. Images on the LCD	30. •In places subject to low	30. •Adjust the brightness and
monitor appear dark or	temperature, images become	angle of the LCD monitor
whitish.	dark due to the characteristics	(☞ pg. 22, 23).
	of the LCD monitor. When
	this happens, the displayed
	colours differ from those that
	are actually recorded. This is
	not a defect of the camcorder.
	•When the LCD monitor's
	fluorescent light reaches the
	end of its service life, images
	on the LCD monitor become
	dark. Consult your nearest
	JVC dealer.
31. The rear of the LCD	31. •The light used to illuminate	31. •Close the LCD monitor to
monitor is hot.	the LCD monitor causes it to	turn it off or set the Power
	become hot.	Dial to “OFF”, and let the
		unit cool down.
32. The indicators and the	32. •This may occur when the	32.
image colour on the LCD	surface or the edge of the	————
monitor are not clear.	LCD monitor is pressed.
33. Images on the LCD	33. •The speaker volume is too	33. •Turn the speaker volume
monitor are jittery.	great.	down (☞ pg. 49).
34. The LCD monitor and the	34.	34. •Wipe them gently with soft
lens have become dirty	————	cloth. Wiping strongly can
(ex. fingerprints).		cause damage.

CONTINUED ON NEXT PAGE