JVC LYT0191-001B LCD monitor Certain FADE/WIPE, P.AE Indications blink, Two or three times

74EN

TROUBLESHOOTING(Cont.)

SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION

35. The LCD monitor	35. •Certain FADE/WIPE, P.AE/
indications blink.	Effects, DIS and other functions
	that cannot be used together
	are selected at the same time.

35.• Re-read the sections covering FADE/WIPE, P.AE/ Effects and DIS (☞ pgs. 32, 35 – 42).

36. Coloured bright spots	36. •The LCD monitor or the	36.
appear all over the LCD	viewfinder is made with
monitor or the viewfinder.	high-precision technology.
	However, black spots or
	bright spots of light (red,
	green or blue) may appear
	constantly on the LCD	————
	monitor or the viewfinder.
	These spots are not recorded
	on the tape. This is not due
	to any defect of the unit.
	(Effective dots: more than
	99.99 %)
37. The LCD monitor	37. •During playback of the	37.
indications are distorted.	unrecorded portion, High-
	speed Search and still	————
	playback, LCD monitor
	indications appear distorted.
	This is not a defect.
38. An unusual mark appears	38.	38. • Check the section of the
in the LCD monitor or the	————	manual that explains LCD
viewfinder.		monitor/viewfinder indica-
		tions (☞ pgs. 79 – 81).
39. An error indication	39. •A malfunction of some kind	39. • Remove the power supply
(E01 — E06) appears in	has occurred. In this case	(battery pack, etc.) and press
the LCD monitor or the	the camcorder’s functions	RESET button, and wait a few
viewfinder.	become unusable.	minutes for the indication to
		clear. When it does, you can
		resume using the camcorder.
		If the indication remains even
		though you repeat the above
		two or three times,
		please consult your nearest
		JVC dealer.
40. The charge indicator on	40. •The temperature of the	40. • To protect the battery, it is
the AC Charger Station	battery is extremely high/low.	recommended to charge it
does not light.	•Charging is difficult in places	in places with a temperature
	subject to extremely high/low	of 10°C to 30°C (☞ pg. 9).
	temperatures.
41. The recording mode	41. •This occurs when recording	41.
indicator “LP” blinks on	in the LP mode is not
the LCD monitor or the	available. After the indicator	————
viewfinder.	blinks, the recording mode
	switches to “SP” and
	recording goes on.
42. Picture does not appear	42. •The viewfinder is pulled out.	42. • Push the viewfinder back in.
on the LCD monitor.	•The LCD monitor's bright-	• Adjust the brightness of the
	ness setting is too dark.	LCD monitor (☞ pg. 22).

• If the monitor is tilted upward 180 degrees, open the monitor fully (☞ pg. 23).

43.When the image is printed 43. •This is not a malfunction. from the printer, a black

bar appears at the bottom of the screen.

43.• By recording with Digital Image Stabilizer set to “ON” (☞ pg. 32) this can be avoided.