Panasonic WV-CLR920A White Balance Setting White BAL, Auto-Tracing White Balance Mode ATW

Notes:

•When the “I” cursor reaches the “+” end, it jumps back to “–”. At the same time, COARSE is incremented by one step to enable a continu- ous adjustment. The reverse takes place when the “I” cursor reaches the “–” end.

•When L or M is kept pressed for a second or more, the “I” cursor moves faster.

•To reset COARSE and FINE to the values pre- set at the factory, press L and M simultane- ously. COARSE and FINE adjustments are pre- set at the factory to zero-crossing of the AC line phase.

•If the AC line contains noise (spike noise, etc.), the stability of the vertical phase of the camera video output signal may be disturbed.

7.White Balance Setting (WHITE BAL)

7-1. Auto-Tracing White Balance Mode (ATW)

You can select one of four modes for white balance adjustment as follows:

•ATW1 (Auto Tracing White Balance 1)

In this mode, the colour temperature is monitored continuously and thereby white balance is set auto- matically. The colour temperature range for the proper white balance is approximately 2 600 -

-40-

6 000K. Proper white balance may not be obtained under the following conditions:

1. The colour temperature is out of the 2 600 - 6 000K range.

2.When the scene contains mostly high colour temperature objects, such as a blue sky or sun- set.

3.When the scene is dim.

In these cases, select the AWC mode.

Move the cursor to WHITE BAL and select ATW1. The white balance of the camera is automatically set.

** CAM SET UP **

CAMERA ID	OFF	↵
ALC/ELC	ALC	↵
SHUTTER	OFF
AGC	ON(DNR-H)↵
SENS UP	OFF
SYNC	INT
WHITE BAL	ATW1		↵
MOTION DET	OFF
LENS DRIVE	DC

RET

•ATW2 (Auto Tracing White Balance 2) Auto-tracing white balance of the sodium light mode (ATW2)

In case that you select ATW2 for sodium light, white balance is set automatically (Operation is not need- ed).