Panasonic HXA100D Using this unit underwater, Caring for this unit after using it underwater

Page 10

Using this unit underwater

≥Use this unit underwater at a depth of down to 1.5 m (5 feet) with the water temperature between 0 oC and 35 oC (32 oF and 95 oF).

≥Do not use this unit at a depth of over 1.5 m (5 feet).

≥Do not use it in hot water over 35 oC (95 oF) (in a bath or hot spring).

≥Do not use this unit underwater not longer than 30 minutes continuously.

≥Do not open or close the side cover.

≥Do not apply shock to this unit underwater. (Waterproof performance may not be maintained, and there is a chance of water leak.)

≥Do not dive into the water holding this unit. Do not use this unit in a location where the water will splash strongly, such as rapid flow or waterfall. (Strong water pressure may be applied, and it may cause malfunction.)

≥This unit will sink in the water. Take care not to drop this unit.

Caring for this unit after using it underwater

Do not open or close the side cover until the sand and dust is removed by rinsing the camera with water.

Make sure to clean the camera after using it.

≥Thoroughly wipe off any water droplets, sand, and saline matter on your hands, body, hair, etc.

≥It is recommended to clean the camera indoors, avoiding places where water spray or sand may fall.

Do not leave this unit uncared for longer than 60 minutes after using it underwater.

≥Leaving this unit with foreign objects or saline matter on it may cause damage, discoloration, corrosion, unusual odour, or deterioration of the waterproof performance.

1 Rinse with water with the side cover closed.

≥After use at the seaside or underwater, soak the unit in fresh water pooled in a shallow container for about 10 minutes.

2 Drain water by holding this unit and shaking it lightly a few times.

≥After using this unit at the seaside or underwater, or after washing it, water will remain at the speaker site or mic site of this unit for a while and it may cause lower sound or sound distortion.

≥Pay careful attention to prevent this unit from dropping.

3 Wipe off water drops on this unit with a soft, dry cloth and dry this unit in a shaded area that is well ventilated.

≥Dry this unit approx. 1 hour or more.

≥Dry this unit on a dry cloth.

≥Do not dry this unit with hot air from dryer or similar. It will deteriorate the waterproof performance or cause failure due to deformation.

≥Do not use chemicals such as benzine, thinner, alcohol or cleanser, soap or detergents.

4 Confirm that there are no water droplets, open the side cover, and wipe off any water droplets or sand left inside using a soft, dry cloth.

≥Water droplets may adhere to the card, etc. when the side cover is opened without thoroughly drying. Also, water may accumulate in the gap around the card slot or the terminal connector. Be sure to wipe any water off with a soft, dry cloth.

≥The water droplets may seep into this unit when the side cover is closed while it is still wet, causing condensation or failure.

In case water enters this unit, stop the use and consult your dealer.

Malfunctions resulting from water leakage due to wrong handling by customers are not subject to compensation.

10

VQT4X87

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Wearable Camera Dear Customer Following Applies only in the U.S.A FCC NoteContains FCC ID VPYLBVX532 Contains IC 772C-LBVX604Important Safety Instructions If you see this symbol About connecting to a PCContents Important About the Waterproof/ Dustproof Handling of this unitWhat to do when inner side of the lens is fogged When inner side of the lens is fogged condensationCheck before using underwater Slide the side cover downward to open itUsing this unit underwater Caring for this unit after using it underwaterAccessories  Read this first What you can do with this unit Playback on DLNA-compatible devicesFasten to your arm Wearing this unitAbout the Armband Case How to attach the adjuster Large Supplied How to remove Camera Unlock Power supply Charging the batteryCharging and recording time Check that the access lamp a has gone off Recording to a cardTurn this unit on/off About the access lampPress the power button to turn on this unit To turn off this unitUse this unit as a wireless LAN device Wi-FifunctionBefore use Connecting with a WPS-compatible smartphone Press and hold the Wi-Fi/WPS button for 3 seconds or more≥ Password entry screen is displayed Set the Wi-Fi function to on on the smartphone setup menuEnter password below Selecting Ssid of this unit to connect with a smartphoneWhen connecting by If the device is Android Setting up with Setup WizardChange the Ssid and password for this unit Tap Tap the wireless access point to connect Enter passwordSetting date and time Tap # Camera setup Tap Date & timeTap the motion picture recording icon to start RecordingTap About recording with this unitPlayback Copy using Picture Share settingsTo copy the data stored in this unit to the smartphone Recording modes/approximate recordable time Approximate number of recordable picturesThis may cause leaking, overheating, fire or rupture Requests when disposing of this unitBattery used for this unit Keep removed screws etc. out of the reach of small childrenHow to remove the battery Regarding the handling of used batteriesSpecifications Optional accessories Accessory No DescriptionCarefully observe copyright laws About copyrightLicenses Accessory Order Form For USA and Puerto Rico Customers VisaPanasonic Products Limited Warranty Limited Warranty Limits And Exclusions For hearing or speech impaired TTY users, TTYWarranty For Canadian Customers Panasonic Canada Inc01-8000-94PANA PanaVQT4X87 VQT4X87 Panasonic Canada Inc
Top Page Image Contents