Panasonic HXA100K, HX-A100K How to remove the battery, Regarding the handling of used batteries

Page 29

How to remove the battery

When disposing of your used products, delete personal information from this unit by initializing the network settings.

This figure describes the disposal of this unit, it is not instruction for repair. If disassembled, repair is not possible.

≥Disassemble after the battery runs out.

≥If it cannot be removed smoothly, contact Panasonic’s Service Center.

≥Keep disassembled parts out of reach of children.

1Open the side cover, and remove all of the 6 screws indicated in the

figure below.

≥Use a cross-slot screwdriver (commercially available).

2Remove the circuit board on the front side (button side) of this unit, and remove the flexible circuit board A.



3After pulling out the built-in battery connector B, pull out the flexible circuit board C, and pull out the speaker connectorD upwards.



 

4Remove the 4 screws indicated in the figure below, and remove the heatsink E.



5Remove the connector F of the camera unit, and lift up the circuit board.



6Remove the battery by using a screwdriver.

Regarding the handling of used batteries

≥Insulate the terminals with cellophane tape or similar.

≥Do not disassemble.

29

VQT4X87

Image 29

Contents Wearable Camera Dear Customer FCC Note Following Applies only in the U.S.AContains IC 772C-LBVX604 Contains FCC ID VPYLBVX532Important Safety Instructions About connecting to a PC If you see this symbolContents Handling of this unit Important About the Waterproof/ DustproofCheck before using underwater When inner side of the lens is fogged condensationWhat to do when inner side of the lens is fogged Slide the side cover downward to open itCaring for this unit after using it underwater Using this unit underwater  AccessoriesRead this first Playback on DLNA-compatible devices What you can do with this unitAbout the Armband Case Wearing this unitFasten to your arm  Unlock How to remove CameraHow to attach the adjuster Large Supplied Charging the battery Power supplyCharging and recording time Recording to a card Check that the access lamp a has gone offPress the power button to turn on this unit About the access lampTurn this unit on/off To turn off this unitBefore use Wi-FifunctionUse this unit as a wireless LAN device Press and hold the Wi-Fi/WPS button for 3 seconds or more Connecting with a WPS-compatible smartphoneEnter password below Set the Wi-Fi function to on on the smartphone setup menu≥ Password entry screen is displayed Selecting Ssid of this unit to connect with a smartphoneChange the Ssid and password for this unit Setting up with Setup WizardWhen connecting by If the device is Android Tap Tap the wireless access point to connect Enter passwordTap # Camera setup Tap Date & time Setting date and timeTap RecordingTap the motion picture recording icon to start About recording with this unitTo copy the data stored in this unit to the smartphone Copy using Picture Share settingsPlayback Approximate number of recordable pictures Recording modes/approximate recordable timeBattery used for this unit Requests when disposing of this unitThis may cause leaking, overheating, fire or rupture Keep removed screws etc. out of the reach of small childrenRegarding the handling of used batteries How to remove the batterySpecifications Accessory No Description Optional accessoriesLicenses About copyrightCarefully observe copyright laws Visa Accessory Order Form For USA and Puerto Rico CustomersPanasonic Products Limited Warranty For hearing or speech impaired TTY users, TTY Limited Warranty Limits And ExclusionsPanasonic Canada Inc Warranty For Canadian CustomersPana 01-8000-94PANAVQT4X87 VQT4X87 Panasonic Canada Inc