Panasonic NV-GS60GN Quick start, To cancel Quick Start, ≥Set to Tape Recording Mode

Page 12

LSQT1174ENG.book 12 ページ ２００７年１月２９日 月曜日 午後１時２８分

Before using

Quick start

When quick start is on the battery power is still being consumed, even when the LCD monitor and the viewfinder are closed.

The camera will resume recording/pause mode about 1.7 seconds after the LCD monitor or the viewfinder is reopened.

≥Please note in quick start mode approximately half the pause recording power is being consumed. Using quick start mode will reduce the battery recording/playback time.

≥This is only activated in the following cases. ≥While using the battery

A tape is inserted, while the Tape Recording Mode is set.

≥While using the AC adaptor

Quick Start can be used even if a tape is not inserted.

≥Set to Tape Recording Mode.

1Set [SETUP] >> [QUICK START] >> [ON]. (-16-)

2While the [OFF/ON] switch is still set to [ON], close the LCD monitor and retract the viewfinder.

OFFON

≥The status indicator lights green and the unit goes into quick start standby mode.

≥The movie camera will not go into quick start standby unless the LCD monitor is closed and the viewfinder is retracted.

3Open the LCD monitor or extend the viewfinder.

OFFON

≥The status indicator lights red and the camera is put into recording pause approx.

1.7 seconds after it is turned on.

ªTo cancel Quick Start

1Set [SETUP] >> [QUICK START] >> [OFF]. (-16-)

≥If the [OFF/ON] switch is set to [OFF] while the unit is in quick start standby, the power turns off.

≥If the standby continues for approx. 30 minutes, then the status indicator will go off and the camera will be completely turned off.

≥In the following cases, quick start is cancelled and the power turns off.

≥When the Mode dial is moved.

≥When the battery or AC adaptor is removed. ≥When the tape is removed while using the

battery in Tape Recording Mode.

≥When the camera is quick-started with the white balance on automatic, it may take some time until the white balance is adjusted if the scene being recorded has a light source different from the scene last recorded. (When the colour night view function is used, however, the white balance of the scene last recorded is retained.)

≥If the power is turned on in quick start standby, the zoom magnification becomes 5k and the picture size may differ from what it was before quick start standby.

≥If [POWER SAVE] (-36-) is set to [5 MINUTES] and the unit automatically goes into quick start standby mode, set the [OFF/ON] switch to [OFF], then to [ON] again. Also, close the LCD monitor and retract the viewfinder and then open the LCD monitor or extend the viewfinder again.

12

LSQT1174

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Operating Instructions Information for your safety Manufacturer is not liable for loss of recorded contentsCarefully observe copyright laws Pages for referenceLSQT1174ENG.book 3 ページ ２００７年１月２９日 月曜日 午後１時２８分 Contents Before using AccessoriesOptional Parts identification and handlingShoulder strap fixture Adjust the belt length Fitting the lens capGrip belt Power supply How to turn on the power How to turn off the powerCharging time and recordable time Turning the camera onSetting date and time Recharging the built-in lithium batteryAbout date/time Using the LCD monitor Using the viewfinderAdjusting the field of view Adjust the focus by sliding the eyepiece corrector knobTo cancel Quick Start ≥Set to Tape Recording ModeQuick start Open the LCD monitor or extend the viewfinderWhen the cassette holder does not Come out When the cassette holder cannot be HousedInserting/removing a cassette Accidental erasure preventionSelecting a mode How to use the joystickBasic joystick operations Joystick and screen displayHelp mode To exit the Help modeTape Playback Mode Switching the language Using the menu screenAbout the menu setting To exit the menu screenAdjusting LCD monitor/viewfinder Adjusting the brightness and colour LevelEVF Brightness of the viewfinder Record mode Check before recordingOn-screen display in the tape recording mode Recording on a tapeRecording check Concerning the remaining tape time Indication on the screenBlank search function Recording a still picture on a tape PhotoshotStopping blank search midway Through Continuous photoshotZoom in/out function Recording yourselfDigital zoom function About the variable speed zoom FunctionTo cancel the colour night view Function Backlight compensation functionColour Night view function To return to normal recordingSoft skin mode To cancel the soft skin modeTo cancel fading Fade in/fade out functionTo cancel the wind noise reduction Function To cancel the Cinema functionWind noise reduction function Recording images for wide-screen TVsRecording in various situations Scene mode To cancel the image stabilizer functionImage stabilizer function To cancel the scene mode function Recording in natural colours White balanceMove the joystick up to select the white balance icon Manual focus adjustment To restore to the automatic AdjustmentTo set the white balance manually About flashing of the indicationManual shutter speed/aperture adjustment To restore to automatic adjustmentShutter speed range Iris/gain value rangePlayback mode To adjust volumeSettings on the audio Playing back tapeFrame-by-frame playback Playback on TVTo return to normal playback Edit mode Using the DV Cable for Recording Digital DubbingCopying onto a DVD recorder or a VCR Dubbing Stop playback. PlayerUsing the movie camera as a Web Camera Windows XP SP2 To cancel the standby for recordingSoftware Using on Macintosh When you use the movie camera as a Web CameraOperating environment on iMovie IMovie HD InterfaceLSQT1174ENG.book 34 ページ ２００７年１月２９日 月曜日 午後１時２８分 Menu Menu listTape Recording Menu Tape Playback MenuMenus related to taking pictures Menus related to playback Other menusOthers IndicationsFunctions cannot be used simultaneously Wrong Tape FormatBefore requesting repair Problems and solutions Auto focus function does not work Remaining tape time indication disappearsDifferent sounds are reproduced at the same time Sounds cannot be played backAbout condensation Clean the heads with the digital video head cleaner About dirty headsAbout the movie camera About the battery Be sure to detach the battery after usePrepare spare batteries when going out for recording Do not throw old battery into fireAbout the AC adaptor About the cassettePeriodical check-ups Explanation of terms Automatic white balanceWhite balance Auto focusSpecifications SpecificationsWeb site http//panasonic.net
Top Page Image Contents