Panasonic NV-GS60GN operating instructions Setting date and time, About date/time

Page 10

LSQT1174ENG.book 10 ページ ２００７年１月２９日 月曜日 午後１時２８分

Before using

ªHow to turn the power on and off with

the LCD monitor/viewfinder

When the power switch is set to [ON], the power can be turned on and off with the LCD monitor and the viewfinder when the unit is in Tape Recording Mode.

OFF ON

1Open the LCD monitor out or extend the viewfinder to use. (-11-)

≥The LCD monitor or the viewfinder will be activated.

2Close the LCD monitor and retract the viewfinder.

OFFON

≥The power will not turn off unless the LCD monitor is closed and the viewfinder is retracted.

≥The status indicator automatically goes off and the power turns off. (If quick start is set to [ON] (-12-), the unit goes into quick start standby mode and the status indicator lights green.)

≥The power does not turn off even if the LCD monitor is closed and the viewfinder is retracted while recording on a tape.

3Open the LCD monitor or extend the viewfinder to turn the power on and use the movie camera again.

OFFON

≥The status indicator lights red and the power turns on.

Setting date and time

When the movie camera is turned on for the first time, [SET DATE AND TIME] will appear.

≥Select [YES] and press the centre of the joystick. Do steps 2 and 3 below to set the date/ time.

If the screen shows the incorrect date/time, then adjust it.

≥Set to Tape Recording Mode.

1Set [BASIC] >> [CLOCK SET] >> [YES]. (-16-)

2Move the joystick left or right in order to select the item to be set. Then move the joystick up or down to set the desired value.

≥The year will change as follows: 2000, 2001, ..., 2089, 2000, ...

≥The 24-hour clock is used.

3Press the joystick to determine the setting.

≥The clock function starts at [00] seconds.

ªAbout date/time

≥The date and time function are driven by a built-in lithium battery.

≥Make sure to check the time before recording because the built-in clock is not very accurate.

ªRecharging the built-in lithium battery

≥If [0] or [--] is appears when the camera is turned on, then the built-in lithium battery has run down. Use the steps below to charge the battery. When turn on the power for the first time after charging, [SET DATE AND TIME] will appear. Select [YES] and set the date and time. Connect the AC adaptor to the camera or attach the battery to the camera, and the built-in lithium battery will be recharged. Leave the camera as is for approx. 24 hours, and the battery will drive the date and time for approx. 6 months. (Even if the [OFF/ON] switch is set to [OFF], the battery is still being recharged.)

10

LSQT1174

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Operating Instructions Carefully observe copyright laws Information for your safetyManufacturer is not liable for loss of recorded contents Pages for referenceLSQT1174ENG.book 3 ページ ２００７年１月２９日 月曜日 午後１時２８分 Contents Optional Before usingAccessories Parts identification and handlingShoulder strap fixture Fitting the lens cap Adjust the belt lengthGrip belt Power supply Charging time and recordable time How to turn on the powerHow to turn off the power Turning the camera onRecharging the built-in lithium battery Setting date and timeAbout date/time Adjusting the field of view Using the LCD monitorUsing the viewfinder Adjust the focus by sliding the eyepiece corrector knobQuick start To cancel Quick Start≥Set to Tape Recording Mode Open the LCD monitor or extend the viewfinderInserting/removing a cassette When the cassette holder does not Come outWhen the cassette holder cannot be Housed Accidental erasure preventionBasic joystick operations Selecting a modeHow to use the joystick Joystick and screen displayTo exit the Help mode Help modeTape Playback Mode About the menu setting Switching the languageUsing the menu screen To exit the menu screenAdjusting the brightness and colour Level Adjusting LCD monitor/viewfinderEVF Brightness of the viewfinder Record mode Check before recordingRecording check On-screen display in the tape recording modeRecording on a tape Concerning the remaining tape time Indication on the screenStopping blank search midway Through Blank search functionRecording a still picture on a tape Photoshot Continuous photoshotDigital zoom function Zoom in/out functionRecording yourself About the variable speed zoom FunctionColour Night view function To cancel the colour night view FunctionBacklight compensation function To return to normal recordingTo cancel fading Soft skin modeTo cancel the soft skin mode Fade in/fade out functionWind noise reduction function To cancel the wind noise reduction FunctionTo cancel the Cinema function Recording images for wide-screen TVsTo cancel the image stabilizer function Recording in various situations Scene modeImage stabilizer function Recording in natural colours White balance To cancel the scene mode functionMove the joystick up to select the white balance icon To set the white balance manually Manual focus adjustmentTo restore to the automatic Adjustment About flashing of the indicationShutter speed range Manual shutter speed/aperture adjustmentTo restore to automatic adjustment Iris/gain value rangeSettings on the audio Playback modeTo adjust volume Playing back tapePlayback on TV Frame-by-frame playbackTo return to normal playback Copying onto a DVD recorder or a VCR Dubbing Edit modeUsing the DV Cable for Recording Digital Dubbing Stop playback. PlayerTo cancel the standby for recording Using the movie camera as a Web Camera Windows XP SP2Software Operating environment on iMovie IMovie HD Using on MacintoshWhen you use the movie camera as a Web Camera InterfaceLSQT1174ENG.book 34 ページ ２００７年１月２９日 月曜日 午後１時２８分 Tape Recording Menu MenuMenu list Tape Playback MenuMenus related to taking pictures Menus related to playback Other menusOthers IndicationsFunctions cannot be used simultaneously Wrong Tape FormatBefore requesting repair Problems and solutions Different sounds are reproduced at the same time Auto focus function does not workRemaining tape time indication disappears Sounds cannot be played backAbout condensation About dirty heads Clean the heads with the digital video head cleanerAbout the movie camera Prepare spare batteries when going out for recording About the batteryBe sure to detach the battery after use Do not throw old battery into fireAbout the cassette About the AC adaptorPeriodical check-ups White balance Explanation of termsAutomatic white balance Auto focusSpecifications SpecificationsWeb site http//panasonic.net
Top Page Image Contents