Panasonic WV-CW484F operating instructions Camera fixing screw

7. Secure the camera unit to the bracket with the camera lock screw.

(The illustration describes an example using a junction box.)

Camera fixing screw

8. Adjust the camera. (Refer to p. 21.)

9. Attach the dome cover to the camera. Firmly tighten the three tamper-proof screws.

(Recommended torque 0.78 N·m {0.08 kgf·m}

Notes:

•Defocus may be caused by the reinstalled dome cover. When using a system controller, adjust the back focus on the setup menu after attaching the dome cover.

•When not using a system controller, back focus adjustment is available by using the [ABF2] button after attaching the dome cover.

q Press the [ABF2] button. The LED indicator will start blinking.

w While the LED indicator is blinking (for around 3 minutes), attach the dome cover to the camera.

e When the LED indicator changes to steady light, back focus will be adjusted automati- cally.

r After the back focus is adjusted, the LED indicator will go out.

Notes:

•Do not aim the camera to objects continuously moving.

•If the LED indicator blinks again after changing to steady light, back-focus adjust- ment may have failed. In this case, check the back-focus on the LCD monitor. To adjust the back-focus again, perform Step 1 to 3 again.

18