Panasonic WV-CW484F operating instructions Basic operation

■Basic operation

The following are descriptions of how to configure each setup item using the operation buttons (refer to p. 10) on the camera. Setup using an optional system controller is also available.

Note:

The illustrations below are the examples to be displayed on a video monitor.

1.Hold down the [SET] button for around 2 sec- onds.

→The top page will be displayed.

2.Move the cursor onto "END" by press the [UP] or [DOWN] button.

3.Press the [SET] button after moving the cur- sor onto "SETUP" by pressing the [RIGHT] button.

→The "DISABLE" indication will change into "ENABLE" and the settings will become editable.

4.Move the cursor onto the desired setup item and press the [SET] button.

→The setup page of the selected setup item will be displayed.

5.Configure the settings for each item.

Select setup item: Move the cursor by pressing the [UP] or [DOWN] button.

Change the parameter: Press the [LEFT] or [RIGHT] button.

Display the detailed settings page of the

setup item: Press the [SET] button when the setup item with the [O] mark is selected.

Go back to the previous page: Move the cursor onto "RET" and press the [SET] button.

Go back to the top page: Move the cursor onto "TOP" and press the [SET] button.

MODEL WV-CW484 SERIES CAMERA

BACK-FOCUS SPECIAL LANGUAGE

END SETUP DISABLE

MODEL WV-CW484 SERIES CAMERA

BACK-FOCUS SPECIAL LANGUAGE

END	SETUP ENABLE
**CAMERA SETUP** 1/2
CAMERA ID		OFF
ALC		ALC
SHUTTER		OFF
AGC		ON(HIGH)
SENS UP		OFF
SYNC		INT
WHITE BAL		ATW1
MOTION DET		OFF
DNR		HIGH
RESOLUTION		HIGH
BW MODE

**CAMERA SETUP** 2/2

PRIVACY ZONE OFF

EL-ZOOM OFF

UPSIDE-DOWN OFF

STABILIZER OFF

LENS PANASONIC

RET TOP END

29