Panasonic WV-CW484F Optional Heater Unit WV-CW4H, Introduction, Installation

■Optional Heater Unit WV-CW4H

●Introduction

Installing this heater unit enables the camera to operate in a low-temperature environment below –30 °C {–22 °F}. The heater turns on automatically when the temperature inside the cam- era drops below +10 °C {50 °F} and turns off when the temperature rises.

A small fan inside the unit will minimize condensation on the surface of the dome cover caused by changes in ambient temperature unless temperatures change too rapidly. The fan will stop when there is no possibility of condensation.

Cautions:

•When using 12 V DC power supply, the optional heater unit is unavailable.

•Turning the heater on and off may disturb the camera images.

•When servicing, pay attention to high temperature on the surface of the heater unit. Disconnect the harness and wait until the heater unit cools.

•When you install and operate the camera in a low-temperature environment below –10 °C {14 °F}, it may take time (around 30 minutes) for the inside of the camera to warm up. In such a case, wait around 30 minutes or more.

●Installation

1.Open the dome cover.

2.Place the heater unit in the camera and fix it with the supplied screw (x1).

3.Insert the harness (x1) into the heater unit connector of the camera.

Note: Attach the desiccant pack so that it does not block ventilation holes or hang over the top of the wall.

4.Attach the dome cover.

Note: Do not to pinch the harness cable.

5.Connect the heater power cable of the camera. (Refer to p. 23 Connections.)

Heater unit screw

Optional heater connector

25