DeWalt DWE4519 Assembly And Adjustments, Attaching the Side Handle Fig, Operation, AnACHM ENTS

accessoriesrunningoverratedspeedcanflyapartandcauseinjury. Accessoryratingsmustalwaysbeabovetoolspeedasshownon toolnameplate.

A'n'ACHM ENTS

Attachments designed specifically for this grinder can be purchased through DEWALT dealers and DEWALT Factory Service centers.

9" Type	27 guard	D284939
9" Type	28 guard	D284938
7" Type	27 guard	D284937
6" Type	11 Flaring cup guard with flange	D284936
4" Type	11 Flaring cup guard with flange	D284934
Type 11 Flaring cup wheel backing flange		608368-00
Type 1 Flange set		D284932
7" Type	1 Guard	D284931
Grinding backing flange		54339-00
Clamp nut		22191-00
Wheel Wrench		61820-01
Soft mount spindle protector		445928-01

ASSEMBLY AND ADJUSTMENTS

A WARNING: To reduce the risk of injury, turn unit off

and disconnect it from power source before installing and removing accessories, before adjusting or when making

repairs. An accidental start-up can cause injury.

Attaching the Side Handle (Fig. 3)

Attach the side handle (C) to one of the two	FIG. 3
side handle ports (H).	/

Rotating the Gear Case (Fig. 4)

1.Remove guard and flanges from FIG.4 tool.

2.Remove the four corner screws attaching the gear case to motor housing.

3.Separate the gear case from motor housing, not more than 1/4" (6.35 mm), rotate the gear case head to desired position.

NOTE: If the gear case and motor housing become separated by more than 1/4" (6.35 mm), the tool must be serviced and re-assembled by a DEWALT service center. Failure to have the tool serviced may cause brush, motor and bearing failure.

4.Re-install screws to attach the gear case to the motor housing. Tighten screws to 20 in./Ibs, torque. Overtightening could cause screws to strip.

OPERATION

A WARNING: To reduce the risk of injury, turn unit off and disconnect it from power source before installing and removing accessories, before adjusting or when making repairs. An accidental start-up can cause injury.