DeWalt DWE4519 FIG7, guardinto the desiredworking, positionthat providesmaximum, closedposition

3.Withtheguardlatchopen,rotatethe		FIG7.
guardinto the desiredworking
positionthat providesmaximum
protectiontotheuserasshown.
4.Closetheguardlatchtosecurethe
guardonthegearcaseYoushould.
be unableto rotatetheguardby
handwhenthelatchisclosedDo.
notoperatethegrinderwithaloose
guardor theguardlatchin open
position.
5.Toremovetheguard,followthe
procedureaboveinreverseorder.
NOTE"Theguardis pre-adjustedto
thediameterof thegearcasehubat
thefactoryIf,. aftera periodof time,
theguardbecomesloose,tightenthe
adjustingscrew(J)withclampin the
closedposition.
NOTICE: Do not tighten the adjusting
screw with the guard latch in open
position. Undetectable damage to the
guard or the mounting hub may result.		"J
Mounting and Removing	Hubbed Wheels

Hubbed wheels install directly on the 5/8"-11 threaded spindle.

1.Thread the wheel on the spindle by hand, seating the wheel against the soft mount.

2.Depress the spindle lock button and use a wrench to tighten the hub of the wheel.

3.Reverse the above procedure to remove the wheel.

Sanding	Flap Discs
soft mount	soft mount
445928-01	445928-01

Type 27 guard		Type 27 guard
D284937	7"	D284937		7"
D284939	9"	D284939		9"
		backing	flange
hubbed sanding		54339-00
flap disc
		non-hubbed	sanding
		flap disc
		clamp	nut
		22191-00

NOTE: Wheel size must match guard size; i.e., a new 7" wheel may not be used with a 9" guard. The bottom surface of wheel must be inside the bend of the guard lip.

11