DeWalt DWE4517, DWE4519 Kickback and Related Warnings, Safety Warnings Specific for Grinding and

j) Position the cord clear of the spinning accessory, if you

lose control, the cord may be cut or snagged and your hand or arm may be pulled into the spinning accessory.

k)Never lay the power tool down until the accessory has come to a complete stop. The spinning accessory may grab the surface and pull the power tool out of your control

I)Do not run the power tool while carrying it at your side. Accidental contact with the spinning accessory could snag your clothing, pulling the accessory into your body.

m)Regularly clean the power tool's air vents. The motor's

fan will draw the dust inside the housing and excessive accumulation of powdered metal may cause electrical hazards.

n)Do not operate the power tool near flammable materials. Sparks could ignite these materials.

o)Do not use accessories that require liquid coolants. Using water or other liquid coolants may result in electrocution or shock.

p)Always use side handle. Tighten the handle securely. The

side handle should always be used to maintain control of the tool at all times.

Kickback and Related Warnings

Kickback is a sudden reaction to a pinched or snagged rotating wheel, backing pad, brush or any other accessory. Pinching or snagging causes rapid stalling of the rotating accessory which in turn causes the uncontrolled power tool to be forced in the direction opposite of the accessory's rotation at the point of the binding.

For example, if an abrasive wheel is snagged or pinched by the workpiece, the edge of the wheel that is entering into the pinch point can dig into the surface of the material causing the wheel to climb out or kick out. The wheel may either jump toward or away from the operator, depending on direction of the wheel's

movement at the point of pinching. Abrasive wheels may also break under these conditions.

Kickback is the result of tool misuse and/or incorrect operating procedures or conditions and can be avoided by taking proper precautions as given below."

a)Maintain a firm grip on the power tool and position your body and arm to allow you to resist kickback forces. Always use auxiliary handle, if provided, for maximum control over kickback or torque reaction during start up. The operator can control torque reaction or kickback forces, if proper precautions are taken.

b)Never place your hand near the rotating accessory. Accessory may kickback over your hand.

c)Do not position your body in the area where power tool will move if kickback occurs. Kickback will propel the tool in direction opposite to the wheel's movement at the point of snagging.

d)Use special care when working corners, sharp edges etc. Avoid bouncing and snagging the accessory. Comers, sharp edges or bouncing have a tendency to snag the rotating accessory and cause loss of control or kickback.

e)Do not attach a saw chain woodcarving blade or toothed saw blade. Such blades create frequent kickback and loss of control

Safety Warnings Specific for Grinding and

Abrasive Cutting-OffOperations

a)Use only wheel types that are recommended for your power tool and the specific guard designed for the selected wheel Wheels for which the power too/ was not designed cannot be adequately guarded and are unsafe.