12 en Connection and mounting | DINION 5000 AN |
|
|
4Connection and mounting
CAUTION!
Before proceeding, disconnect the power from the power supply cable. Ensure that the voltage of the unit matches the voltage and type of the power supply being used.
4.1Power connection
4.1.1Low voltage cameras
VIDEO
1
+
12VDC
24VAC
5 mm
Figure 4.1 Low voltage power connection
Connect power from a 24 VAC or 12 VDC class 2 power supply as follows:
–Use AWG16 to 22 stranded wire or AWG16 to 26 solid wire; cut back 5 mm (0.2 in) of insulation.
–Remove the
–Loosen the screws and insert the wires.
Note
The central connection for System (video) ground is optional. Connecting System ground to Safety ground may result in ground loops that can disrupt the CCTV system.
–Tighten the screws and reconnect the
Installation Manual | Bosch Security Systems |