AXIS P5522–E PTZ Dome Network Camera
Hardware Overview
SD Card Slot
NOTICE
•Risk of damage to SD card. Do not use sharp tools or excessive force when inserting or removing the SD card.
•Risk of data loss. To prevent data corruption, the SD card should be unmounted before removal. To unmount, go to Setup > System Options > Storage > SD Card and click Unmount.
This product supports SD/SDHC/SDXC card (not included).
For SD card recommendations, see www.axis.com
Control Button
For location of the control button, see Hardware Overview on page 7 .
The control button is used for:
•Resetting the product to factory default settings. See page 52.
•Connecting to an AXIS Video Hosting System service. See page 45. To connect, press and hold the button for about 3 seconds until the Status LED flashes green.
•Connecting to AXIS Internet Dynamic DNS Service. See page 45. To connect, press and hold the button for about 3 seconds.
Restart Button
Press the restart button to restart the product.
LED Indicators
Note
• The Status LED can be configured to flash while an event is active.
Status LED | Indication |
|
|
Unlit | Connection and normal operation. |
|
|
Green | Shows steady green for 10 seconds for normal operation after startup completed. |
|
|
Amber | Steady during startup. Flashes during firmware upgrade. |
|
|
Amber/Red | Flashes amber/red if network connection is unavailable or lost. |
|
|
Red | Flashes red for firmware upgrade failure. |
|
|
Midspan LED Indicators
LED | Color | Indication | |
|
|
| |
Port | Unlit | No camera connected. | |
|
|
| |
| Green | Steady when camera connected, normal operation. | |
|
|
|
|
| Green, flashing | Slow flash | when overcurrent or short circuit condition on the port. |
|
|
|
|
| Green, flashing | Fast flash | when input voltage is out of range or other internal error. |
|
|
| |
AC | Green | Steady when AC power input connected. | |
|
|
|
|
9