Configure the settings relating to the alarm output terminal
Select the alarm output operation. Follow the procedure below.
"SYSTEM SETUP" screen | "ALARM IN/OUT" screen | ||||||
| **SYSTEM SETUP** | **ALARM IN/OUT** | |||||
| SYNC | INT | ALARM IN | OFF |
| ||
| ALARM |
| IN/OUT |
| |||
| PRIVACY ZONE | OFF | ALARM OUT | OFF |
| ||
|
|
|
| ||||
| STABILIZER | OFF |
|
|
| ||
| OFF |
|
|
| |||
| RET TOP END |
| RET TOP END |
|
|
Step 1
Move the cursor to "ALARM IN/OUT" and press the setting button.
→The "ALARM IN/OUT" screen appears.
Step 2
Move the cursor to "ALARM OUT" and select the alarm output terminal operation from the following. OFF (default): Does not perform terminal output.
ALARM: The alarm output will be performed upon a
BW: Activates the output terminal while an image is displayed in the black and white mode.
12. Privacy zone setting [PRIVACY ZONE]
When undesired portions in the camera shooting area (on the screen) exist, those portions (privacy zone) are hidden. Up to 8 portions can be specified for the privacy zone.
ON (1): Grays the zone.
ON (2): Mosaics the zone.
OFF (default): Displays the zone normally. Follow the procedure below.
Note:
• The privacy zone function is disabled at initializing the unit, i.e. right after turning on the power.
"SYSTEM SETUP" screen | Zone setting screen | ||||||||||
**SYSTEM SETUP** | **ZONE NUMBER 1 | /8** | |||||||||
SYNC | INT |
|
|
|
| PUSH SW | |||||
ALARM IN/OUT |
|
|
|
| POSITION |
|
|
| |||
|
|
|
|
|
|
| |||||
PRIVACY ZONE |
|
| UPPER LEFT |
| |||||||
ON(1) |
|
| |||||||||
STABILIZER | OFF |
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| ||||
OFF |
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
| DEL |
|
|
|
| ||
RET TOP END |
|
| RET TOP END |
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
Step 1
Move the cursor to "PRIVACY ZONE", select "ON (1)" or "ON (2)", and press the setting button.
→The zone setting screen appears.
24