Panasonic WV-CW484 Motion Detection Setting Motion DET, AWC Setting, Manual Fine Adjustment

LEVEL DWELL TIME

DISPLAY MODE↵

ALARM

MASK SET↵

** MODE1 **

AWC Setting

1.Select AWC and press the [LEFT] button.

→AWC will change to AWC → PUSH SW.

2.Press the [SET] button.

→PUSH SW will be highlighted while the AWC setting is performed.

Note: If the white balance is not set, PUSH SW is being highlighted. 3 . Press the [RIGHT] button.

Manual Fine Adjustment

Perform fine adjustment as necessary.

1.Select WHITE BAL and press the [SET] but- ton.

→Fine adjustment menu of ATW or AWC will open.

2.Adjust finely R (Red) and B (Blue) gain by moving the "I" cursor.

**ATW1**

R...I...128

- +

B...I...128

- +

RET TOP END

8. Motion Detection Setting (MOTION DET)

When a series of changes in pictures is detected, the camera outputs an alarm to the external device such as a disk recorder. The recorder will start recording the pictures.

1.Select a mode for MOTION DET on the CAMERA SETUP menu. The default setting is OFF.

OFF: Disables the alarm output.

MODE1: Outputs alarm when a series of

motions is detected.

MODE2: Outputs alarm when a series of scene changes is detected.

→ The MODE1 menu opens when you select MODE1 and press the [SET] button.

2.	Adjust for LEVEL to optimize the sensitivity of	RET TOP END
	detection.
3.	Select a dwell time. The default setting is 2S.
	Available time (second): 2, 5, 10, 30
	The next detection will be performed after
	the set time elapses.

...I..128

-+

2S

OFF

4. Select MASK SET and press the [SET] but- ton.

→ A 48-split screen opens.

•Specify non-detection (mask) and detection areas in the same way as described earlier in 2-2 ALC Mode.

•Hold down the [SET] button for 2 seconds to return to the MODE1 menu.

Note: Perform the setting of mask area after STABILIZER in the CAMERA SETUP menu is set to OFF.

36