Panasonic GP-US932CU, GP-US932CUE, GP-US932CUS, GP-US932CUSE operating instructions Rear

<Rear>

● GP-US932CU, GP-US932CUE
!4			!5					!6
	V I D E O	S Y N C	O U T	ON	1	OFF	O N
						SD	H D
				1 2 3 4	2	INTER .	P R O G R E .
			I N		3	NOT USE	NOT USE
					4	RS – 232C	FRONT SW	!7
!3
R G B / Y P b P r	S – V I D E O		R S – 2 3 2 C	D C 1 2 V I N
@1	@0		!9				!8

●GP-US932CUS, GP-US932CUSE

!4 !5

!6

1	S D I	2	V I D E O	S Y N C	O U T	ON	1	OFF	O N
								SD	H D
						1 2 3 4	2	INTER .	P R O G R E .
					I N		3	NOT USE	NOT USE
							4	RS – 232C	FRONT SW	!7
		R G B / Y P b P r	S – V I D E O		R S – 2 3 2 C	D C 1 2 V I N

@2 @1 @0

!3HDMI output connector [HDMI] (* only for GP-

US932CU, GP-US932CUE)

This connector is used when an HDMI-ready monitor is connected.

!4Video output connector [VIDEO]

This connector provides composite video signals (1.0 V[P-P], 75 ohms).

!5Synchronizing signal output/input connector [SYNC]

When an external device is synchronized, set the syn- chronizing signal output/input selection switch !6to "IN" to provide the synchronizing signal input.

When the synchronizing signal output/input selection switch !6is set to "OUT", the connector provides the synchronizing signal output conformable to the video format of this system.

Important:

•The video format shall be the same among the syn- chronized devices.

!9 !8

output connector, SDI output connector, and HDMI out- put connector.

Switch		OFF			ON
1	SD (SD signal output)			HD (HD signal output)
2		INTER.			PROGRE.
	(Interlace output)			(Progressive output)
3	NOT USE (Not used)			NOT USE (Not used)
	RS-232C				FRONT SW
4					(Button operation
	(RS-232C control)
					via front face)
Video	Switch		RGB/YPb		SDI	HDMI
format	1	2	Pr output		output	output
1 080i	ON	OFF	b		b	b
720p	ON	ON	b		b	b
480p (576p*)	OFF	ON	b		X	b
480i (576i*)	OFF	OFF	b		b	X

!6Synchronizing signal output/input selection switch [OUT/IN]

This switch toggles synchronizing signals between out- put and input.

When the synchronizing signal output is selected, set this switch to "OUT". When the synchronizing signal input is selected, set this switch to "IN".

!7Function setup switches

These switches select a video format for RGB/YPbPr

X: No output is provided.

*The value is for GP-US932CUE/GP-US932CUSE.

Note:

•When the RS-232C port is used, set Switch 4 to "OFF" after turning off the power.

When Switch 4 is set to "OFF", button operations on the front face are disabled.

11