40 
Note: UPnP must be installed on your workstation. To do this, open the Control Panel from the Start Menu and select Add/Remove Programs. Select Add/Remove Windows Components and open the Net- working Services section. Click Details and then select UPnP as the service to add.
Ports & devices - I/O Ports
The pinout, interface support and the control and monitoring functions are described in the section on the Connection Module, on page 43.
Maintenance
•Restart - The unit is restarted without changing any of the settings. Use this method if the unit is not behaving as expected.
•Restore - The unit is restarted and most current settings are reset to factory default values. The settings that will not be reset are as follows:
•the boot protocol (DHCP or static)
•the static IP address
•the default router
•the subnet mask
•the system time
•Default - The Factory default button should be used with caution. Pressing this button will reset all of the PTZ Network Camera's settings to the factory default values (including the IP address)
Upgrade Server - See Updating the Firmware, on page 45.
Backup - click the Backup button to take a backup of all of the parameters, and any
Note: The root password will also be reset to the password saved in the backup file.
Restore - click the Browse button to locate the saved backup file (see above) and then click the Restore button. The settings will be restored to the previous configuration.
Note: Backup and Restore can only be used on the same unit running the same firmware. This feature is not intended for