Axis Communications Axis 211A manual Adjust the image and focus

AXIS 210/210A/211/211A Installation GuidePage 11

Adjust the image and focus

To focus the AXIS 210/210A,	Focus puller
unscrew the focus puller on
the lens. Adjust the focus as
required. Re-tighten the focus
puller.

To focus the AXIS 211/211A follow the instructions below.

1.From the Basic Configura- tion page in the setup tools, open the Focus adjustment page.

2.Set the DC-Iris to Disabled and click Save.

3.Unscrew the zoom puller on the lens by turning it anti-clockwise. Adjust the zoom setting as required. Re-tighten the zoom puller.

Zoom puller (Tele/wide)

Focus puller

ENGLISH

4.Unscrew the focus puller on the lens. Adjust the focus as required. Re-tighten the focus puller.

5.From the Focus adjustment page, set the DC-Iris to Enabled and click Save.

Note: The DC-Iris should always be disabled while focusing the camera. This opens the iris to its maximum, which gives the smallest depth of field and thus the best conditions for correct focusing. When the focus is set with this method it will then be maintained in any light conditions.

Accessing the AXIS 210/210A/211/211A from the Internet

Once installed, your AXIS 210/210A/211/211A is accessible on your local network (LAN). To access the camera from the Internet, network routers must be configured to allow incoming traffic, which is usually done on a specific port. Please refer to the documentation for your router for further instructions. For more information on this and other topics, visit the Axis Support Web at www.axis.com/techsup