Network disconnect
You can perform the saving/relay/preset operation after receiving an event of a physically disconnected network.
1.From the Setup menu, select the
<Event ( 
)> tab.
2.Click <Network disconnect>.
3.Specify the use of “Network disconnect”.
4.Specify the activation time and activation condition.
For more information about <Activation time> and <Action>, refer to “Alarm input”. (page 66)
5.When done, click [Apply ( 
)].
Tampering
You can set to trigger an event when a scene is changed on the video screen.
1.From the Setup menu, select the
<Event ( 
)> tab.
2.Click <Tampering>.
3.Specify the use of the scene change, and if you set to use it, select a sensitivity.
The higher the sensitivity is, the lesser change can be detected.
4.Specify the activation time and activation condition.
For more information about <Activation time> and <Action>, refer to “Alarm input”. (page 66)
5.When done, click [Apply ( 
)].
J The default change detection function may not work properly in the following cases:
-A monotonous background or a
-A severe shaking of the camera or a drastic change to the illumination can be considered a scene change by mistake.
● SETUP SCREEN