Cisco Systems CIVS-IPC-2500 manual Port Settings, Preset Position

Chapter 3 Configuring and Managing the IP Camera

Applications Windows

If you change any options in the PTZ (RS-485) window, you must click Save to save the changes. To discard the changes, click Cancel before clicking Save. These buttons appear at the bottom of the window. You may need to scroll down to see them.

Table 3-18describes the options in the PTZ (RS-485) window.

Note	These features are not currently supported if you use the IP camera with Cisco VSM.
	Table 3-18	PTZ (RS-485) Window Options
	Option		Description
	Enable External PTZ		Check this check box to enable configuration of the PTZ settings.
	Port Settings
	Baud Rate		Choose the Baud rate value that is configured on the device that controls the
			PTZ functions of the IP camera.
	Data Bits		Choose the data bits value that is configured on the device that controls the
			PTZ functions of the IP camera.
	Parity		Choose the parity value that is configured on the device that controls the PTZ
			functions of the IP camera.
	Stop Bits		Choose the stop bits value that is configured on the device that controls the
			PTZ functions of the IP camera.
	Address		Enter the logical address of the external PTZ device.
			To determine this address, refer to the documentation for that device.
	Preset Position
	Note The Preset Position option appears if you check the Enable External PTZ check box.

Set Preset Position

Click the Set Preset Position button to define a preset position of the IP camera.

When you click this button, the Set Pan/Tilt window appears. For detailed information about this window, see the “Preset Positions Window” section on page 3-30.

	Cisco Video Surveillance System IP Camera User Guide
OL-14220-01		3-29