Cisco Systems CIVS-IPC-2500 manual Address

Chapter 3 Configuring and Managing the IP Camera

Status Windows

		Table 3-24	Syslog and Log Information (continued)
		Message		Explanation
		LOG: Clear all messages.		You have used the Clear Log button to delete the
				log file from the IP camera SDRAM.
		LOG: Log file is full. Start to wrap around.		The IP camera SDRAM is full and existing log
				information is beginning to be overwritten.
		Network: Failed to get the IP address. Camera set		IP camera is unable to obtain an IP address
		to default IP address.		through DHCP and is set to the default IP address
				of 192.168.0.100.
		Network: LAN activated.		IP camera obtained a network IP address.
		NTP: Failed to synchronize data & time with the		Provides information when you configure the IP
		NTP server.		camera to obtains its time from an NTP server.
		NTP: No NTP server specified.
		NTP: Synchronization OK.
		NTP: The NTP server cannot be reached.
		output: Failed to set output port Port_Number.		Provides information when you configure the
				output ports on the IP camera.
		output: Set output port Port_Number to high OK.
		output: Set output port Port_Number to low OK.
		output: Set output port Port_Number to pulse OK.
		PTZ: Go to Preset Position_Number.		Provides information when you pan or tilt the IP
				camera or it move it to a preset position.
		PTZ: Move down.
		PTZ: Move left.
		PTZ: Move right.
		PTZ: Move up.
		PTZ: Zoom in.
		PTZ: Zoom out.
		Stream: HTTP stream started. [id: User, ip:		Provides information when a user accesses (HTTP
		Address]		stream started) or exits (HTTP stream stopped) the
				Home window.
		Stream: HTTP stream stopped. [id: User, ip:
		Address]		User is the IP camera user name of the user.
				Address is the IP address of the PC that was used.
		Stream: RTSP stream started. [ip: Type, UDP:		Provides information when an RTSP stream from
		Address_1:Port_1 ->Address_2:Port_2, User]		the IP camera is initiated (RTSP stream started) or
				stopped (RTSP stream stopped).
		Stream: RTSP stream stopped. [ip: Type, UDP:
		Address_1:Port_1 ->Address_2:Port_2, User]		Type is the type of stream (Video or Audio).
				Address_1:Port_1 are the IP address and port
				number of the IP camera. Address_2:Port_2 are IP
				address and port number of the device that
				receives the stream. User is the IP camera user
				name of the user who started or stopped the
				stream.
		System: Cancel upgrade process		An IP camera administrator cancelled a firmware
				upgrade that was in process.
	Cisco Video Surveillance System IP Camera User Guide
3-36				OL-14220-01